Table of Contents
Advertisement
2.8
Installing a hard disk drive
The system may have one pre-installed 3.5-inch Serial ATA or IDE hard disk
drive. Refer to this section to install additional Serial ATA or IDE hard disk
drive(s).
To install a Serial ATA hard disk drive:
1.
Place the chassis upright.
2.
With the HDD label side up,
carefully insert the drive into
the 3.5-inch bay.
3.
Push the drive into the bay
until its screw holes align with
the holes on the drive bay.
4.
Secure the drive with two
screws on both sides.
5.
Connect one end of the Serial
ATA cable to the SATA
connector at the back of the
drive, then connect the other
end to a Serial ATA connector
on the motherboard. See page
4-6 for the location of the
Serial ATA connectors.
A S U S V i n t a g e - A E 1
A S U S V i n t a g e - A E 1
A S U S V i n t a g e - A E 1
A S U S V i n t a g e - A E 1
A S U S V i n t a g e - A E 1
2
3
H D D s c r e w h o l e s
H D D s c r e w h o l e s
H D D s c r e w h o l e s
H D D s c r e w h o l e s
H D D s c r e w h o l e s
4
3
4
5
6
2 - 1 7
2 - 1 7
2 - 1 7
2 - 1 7
2 - 1 7
Advertisement
Table of Contents
