Asus VINTAGE-AE1 Manual page 34

5. Connect a power cable from
the power supply to the
power connector at the back
of the optical drive.
6. Connect one end of the IDE
ribbon cable to the IDE
interface at the back of the
optical drive, matching the red
stripe on the cable with Pin 1
on the IDE interface.
7. Connect one end of the audio
cable to the 4-pin connector at
the back of the optical drive.
8. Connect the other end of the IDE ribbon cable to the secondary IDE
connector (labeled SEC_IDE) on the motherboard. See page 4-5 for
the location of this connector.
9. Connect the other end of the audio cable to the black 4-pin connector
labeled CD on the motherboard. See page 4-9 for the location of this
connector.
2 - 1 6 2 - 1 6
2 - 1 6 2 - 1 6 2 - 1 6
A u d i o c a b l e A u d i o c a b l e A u d i o c a b l e A u d i o c a b l e A u d i o c a b l e
I D E r i b b o n c a b l e I D E r i b b o n c a b l e
I D E r i b b o n c a b l e I D E r i b b o n c a b l e I D E r i b b o n c a b l e
R e d s t r i p e t o p i n 1 R e d s t r i p e t o p i n 1 R e d s t r i p e t o p i n 1
R e d s t r i p e t o p i n 1 R e d s t r i p e t o p i n 1
P o w e r c a b l e P o w e r c a b l e
P o w e r c a b l e P o w e r c a b l e P o w e r c a b l e
C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n
C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n