Table of Contents
Advertisement
2.1
Preparation
Before you proceed, make sure that you have all the components you plan
to install in the system.
Basic components to install
Basic components to install
Basic components to install
Basic components to install
Basic components to install
1. Central processing unit (CPU)
2. DDR Dual Inline Memory Module (DIMM)
3. Expansion card(s)
4. Hard disk drive
5. Optical drive
6. Floppy disk drive
T o o l
T o o l
T o o l
T o o l
T o o l
Phillips (cross) screw driver
2.2
Before you proceed
Take note of the following precautions before you install components into
the system.
•
•
•
The motherboard comes with an onboard standby power LED. This LED
lights up to indicate that the system is ON, in sleep mode or in soft-off
mode, and not powered OFF. Unplug the power cable from the power outlet
and make sure that the standby power LED is OFF before installing any
system component.
Onboard LED
2 - 2
2 - 2
2 - 2
2 - 2
2 - 2
Use a grounded wrist strap or touch a safely grounded object or a
metal object, such as the power supply case, before handling
components to avoid damaging them due to static electricity.
Hold components by the edges to avoid touching the ICs on them.
Whenever you uninstall any component, place it on a grounded
antistatic pad or in the bag that came with the component.
®
Standby
Power
SB_PWR
ON
OFF
Powered
Off
C h a p t e r 2 : B a s i c i n s t a l l a t i o n
C h a p t e r 2 : B a s i c i n s t a l l a t i o n
C h a p t e r 2 : B a s i c i n s t a l l a t i o n
C h a p t e r 2 : B a s i c i n s t a l l a t i o n
C h a p t e r 2 : B a s i c i n s t a l l a t i o n
Advertisement
Table of Contents
