Assa Abloy NORTON RIXSON Unitrol 8000 Series Installation Instructions

8000 Series Door Closer
Unitrol Arm
®
Non-Hold Open and Hold Open
Installation Instructions
WARNING
This product can expose you to lead which is
known to the state of California to cause cancer
and birth defects or other reproductive harm.
For more information go to:
www.P65warnings.ca.gov.
Standard Frame
1-7/8 to 4-5/8 Frame Reveals (Uses 6190 Bracket)
Bracket illustration page 4
Door and frame preparation page 2
Right Hand Door - RH
Left Hand Reverse - LHR
Left Hand Door - LH
Right Hand Reverse - RHR
NOTE: "DA" sufflix (Delayed Action) is an optional feature, "H" suffix indicates Hold Open Arm.
NOTES:
y For special applications a separate door and frame preparation template is packed with these instructions.
y Use this instruction sheet for installation sequence and closer adjustments only.
y It is recommended that the door on which the door closer will be installed be hung on ball bearing hinges. Door must
swing freely.
y Door and Frame must be properly reinforced, or use of special fasteners employed, to prevent the mounting screw
from pulling out.
y All dimensions are given in inches with corresponding metric dimensions (mm) in parenthesis.
Components
UniTrol Parallel
Arm Assembly
Power Adjustment
Shaft
Backcheck Valve
Delay Valve
(Optional)
Sweep Valve
Latch Valve
Standard Full Cover
Closer Body
Copyright © 2004, 2014, 2023, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in
whole or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
80-9380-2208-020 Rev 3 11/23
Non-Hold Open Arm Models
UNI8101, UNI8301, UNI8501
UNI8101H, UNI8301H, UNI8501H
Frame Reveals Over 4-5/8 (Uses 6191 Clamp Kit)
Bracket illustration page 4
Door preparation page 2
Frame preparation page 3
Right Hand Door - RH
Left Hand Reverse - LHR
Optional Architectural Metal Cover
Soffit
Plate
Main Arm
Hold-Open Option
Optional Narrow Plastic Cover
(8400P) (8200P)
Approved 2024-05-14
Hold Open Arm Models
Deep Frame
Left Hand Door - LH
Right Hand Reverse - RHR
(8400MA)
Optional Metal Cover
(8400M)
Pinion Cap
(1639)
Optional Architectural Plastic
READ AND FOLLOW ALL INSTRUCTIONS.
SAVE THESE INSTRUCTIONS.
An incorrectly installed or improperly
adjusted door closer can cause
property damage or personal injury.
These instructions should be
followed to avoid the possibility of
misapplication or misadjustment.
Flush Transom
Flush Partitions (Uses 2022 Bracket)
Bracket illustration page 4
Door preparation page 2
Frame preparation page 3
Right Hand Door - RH
Left Hand Reverse - LHR
Left Hand Door - LH
Right Hand Reverse - RHR
Arm Part Number
Arm Identification
Non Hold
Door Width
Open
6100-11
28" - 32"
(0.70 - 0.80m) 11-6100-0235
6100-13
33" - 41"
(0.70 - 0.80m) 11-6100-0236
6100-14
42" - 48"
(0.70 - 0.80m) 11-6100-0237
Full Cover (8400A)
Arm Stamping
Hold Open
6100-1
11-6100-0232
6100-3
11-6100-0233
6100-4
11-6100-0234