Assembling Fence To Table - Delta 31-750 Instruction Manual

2 . If an adjustment is necessary, loosen four lock nuts
located underneath the table, three of which are shown
a t ( F ) F i g . 8 .
3 . W ith allen wrench supplied, tighten or loosen adjust-
ment screws (D) and (E) Fig. 9, as necessary. Recheck
t h e table height and repeat the adjustment if needed,
u n t i l t h e table surface is slightly lower than the abrasive
d i s c .
4 . Tighten four lock nuts ( F ) F i g . 8 , a ft e r table height
adjustment.
ASSEMBLING FENCE
TO TABLE
Align two holes (A) Fig. 10, in the underside of fence (B)
with two holes (C) in the table and fasten fence (B) to the
t able from the top, with two lock knobs and flat washers (D).
F i g . 11, illustrates the fence (B) assembled to the sander.
F
D
A
C
D
B
7
F i g . 8
E
D
E
F i g . 9
B
A
C
D
Fig. 10
F i g . 11
F