Select And Install The Table Insert - Delta 31-484 Instruction Manual

SELECT AND INSTALL THE TABLE INSERT

Failure to use the proper insert with the
corresponding spindle may result in
injury and/or damage to the machine or the work piece.
®
Your DELTA Heavy Duty Oscillating Floor Spindle
Sander comes with six table inserts. The table inserts
with the round openings are designed for sanding jobs
where the spindle is in the fully upright (90°) position.
The table inserts with the oblong openings are for
beveled sanding.
1. Using the recommended table inserts shown in
Figure 7, select the desired table insert.
2. Slip the table insert over the spindle. Ensure the
table insert is properly seated by aligning the small
notch in the table insert (A) with the corresponding
small tab (B) in the table as shown in Figure 8.
31-484 INSERT/SPINDLE CHART
INSERT TO USE
SPINDLE
FOR 0°
DIAMETER
4"
3"
2"
1 1/2"
1"
3/4"
5/8"
1/2"
3/8"
1/4"
ASSEMBLY
FOR 45°
E F
D E
D D
C C
B C
B B
A B
A B
A B
A A
A
C
E
10
B
D
F
FIGURE 7
FIGURE 8