Introduction Getting started The Fluke Biomedical ESA710, ESA712 and ESA715 Electrical Safety There are two ways of working with the analyzer: Analyzers are designed to verify the electrical safety of medical devices. They allow users to test equipment against various domestic •...
Intended use The ESA710/ESA712/ESA715 (the product) is intended for use by trained service technicians to perform periodic preventative maintenance on a wide range of equipment. The testing procedures are menu-driven, and simple to operate. The product is an electronic signal source and measurement device for verifying compliance with electrical safety standards.
Safety information Read the safety information and all instructions before you use the • Use only the mains power cord and connector approved for the ESA710/ESA712/ESA715 (the product). voltage and plug configuration in your country and rated for the product. A Warning identifies hazardous conditions and actions that could cause bodily harm or death.
Page 5
• Do not exceed the Measurement Category (CAT) rating of the • Remove the null post adapter from the Ø/Null terminal after a test lowest-rated individual component of a product, probe, or lead zero is performed. The Ø/Null terminal becomes potentially accessory.
General specifications Power (region dependent) ........90–132 V ac, 20 A MAX, 47–63 Hz 90–132 V ac & 180–264 V ac, 15 A MAX, 47–63 Hz 90–132 V ac & 180–264 V ac, 10 A MAX, 47–63 Hz 90–132 V ac & 180–264 V ac, 16 A MAX, 47–63 Hz Safety standard compliance ........
Page 7
Symbols Symbols applicable to the product and user manual. For a full list of applicable product symbols, please visit: www.flukebiomedical.com/resource/certification-sheets. Symbol Description WARNING. RISK OF DANGER. WARING. HAZARDOUS VOLTAGE. Risk of electric shock. Consult user documentation. Power button ...
Need help?
Do you have a question about the ESA700 Series and is the answer not in the manual?
Questions and answers