Chevrolet TAHOE - TRUCK NAVIGATION SYSTEM 2010 Owner's Manual page 86

86 Infotainment System
Voice Tag Commands
The following are voice tag
commands you can access by
clearly stating the commands
exactly as they are written. You may
have up to 40 voice tag entries for
destinations.
Navigation go to [destination]
(voice tag), navigation select
[destination] (voice tag): These
commands instruct the system
to select a destination saved under
the voice tag you have stored.
When a destination is requested
using a voice tag, the system
will state, "Press or say cancel if not
correct". To cancel this voice tag
destination, using voice recognition,
push and hold the SRCE button
on the steering wheel until you
hear a beep, then say "cancel".
Canceling voice tag destination by
voice recognition, must be done
within five seconds after the
voice prompt.
If you are not currently driving on a
route, the system will automatically
create the voice tag destination
as the final destination. If you are
currently driving on a route, the
system will automatically create
the voice tag destination as a
waypoint. Up to three waypoints
can be created.
Storing Voice Tags
From the address book entry
information page, press the Add
Voice tag screen button. The system
will respond "Name Please?".
Navigation Help
Navigation Help: This command
instructs the system to assist
with navigation commands.
Display Commands
Use the following display commands
to set the display mode.
Display [set] day [mode]: Use this
command to set the display to
daytime mode.
Display [set] night [mode]: Use
this command to set the display
to night mode.
Display [set] auto [mode]: Use
this command to set the display to
automatic mode. The system
will change between day and night
mode automatically.
System help: This command
instructs the system to assist with
display commands.
Radio Commands
The following are radio commands
you can access by clearly stating
the commands exactly as they
are written. The commands are only
available when you are in one of
the following audio modes, AM, FM,
or XM™ (if equipped).
Radio: This command instructs the
system to turn the audio system on.