Chevrolet TAHOE - TRUCK NAVIGATION SYSTEM 2010 Owner's Manual page 16

16 Infotainment System
FM source shown,
other sources similar
Category: Touch the screen
button, located in the middle of the
screen, to receive a list of all of
the selected band stations in
the area. Use the up and down
arrow screen buttons to scroll the
frequencies. Touch the desired
frequency.
FM lists may also contain a category
to select if stations in your area
support Radio Data Systems (RDS).
$
Refresh List: Touch this
screen button to refresh the list of
stations.
When viewing a map screen, the
name of the station or channel
will appear on the display.
¨ ©
SEEK / SEEK: To seek
stations, press the left or right arrow
keys to go to the next or previous
station and stay there.
To scan stations, press and
hold either arrow for more than
two seconds. The radio will go to a
station, play for a few seconds,
then go on to the next station.
To stop scanning, press either
arrow again.
Storing Radio Station Presets
This feature allows you to store
up to 30 preset stations. See
"Number of Preset Pages" under
"Radio Menu" later in this section
for more information. You can mix
AM, FM, and XM (if equipped).
To store presets, do the following:
1. Press the O (power) knob to turn
the system on.
2. If viewing a map screen, touch
the source screen button,
press the AUDIO key, or press
the FAV (favorite) key.
3. Select the band.
4. Seek, scan, or tune to the desired
station, to select the station.
5. Press and hold one of the preset
screen buttons for more than
two seconds or until you hear
a beep.
6. Repeat the steps for each preset.