AT&T TL32100 Quick Start Manual page 5

Battery installation and charging
Battery charging
Once you have installed the battery, the screen indicates
the battery status (see the table below). If necessary, place
the handset in the telephone base or charger to charge
the battery. For best performance, keep the handset in the
telephone base or charger when not in use. The battery is
fully charged after 6 hours of continuous charging.
If the screen is blank, you need to charge the handset without interruption
for at least 0 minutes to give the handset enough charge to use the
telephone for a short time. The screen shows Low battery until you have
charged the battery without interruption for at least 0 minutes. The
following table summarizes the battery charge indicators and actions to take.
Battery indicators
The screen is blank or shows
Place in charger.
The screen shows
Low battery and
The screen shows HANDSET X
and the battery icon shows
, or .
NOTES:
• If you are on a call in low battery mode, you hear four short beeps every 50 seconds.
• When you place the handset in the telephone base or charger, if no battery is installed
in that handset, the CHARGE light is off and the screen shows NO BATTERY. Follow the
instructions in Battery installation on page  to install the battery.
Battery has no or very little
charge. The handset cannot
be used.
Battery has enough charge to
be used for a short time.
flashes.
Battery is charged.
Battery status
4
HANDSET 1
10:30
PM
Battery status icon
Action
Charge without interruption
until the screen shows
Low battery or HANDSET X
(at least 0 minutes).
Charge without interruption
until the screen shows
HANDSET X (at least
0 minutes).
To keep the battery charged,
place it in the telephone base
or charger when not in use.
11/20