MELICONI TLC03+ Manual

Remote control for TV sets SONY ready to use
Thank you for choosing a Meliconi remote control.
This remote control, after inserting the batteries, is normally ready for use as it is already set at the
If problems are found to command the TV, or some functions do not produce the desired effect, to follow the instructions
The TLC03+ remote control is designed to command a
The MELICONI remote control reproduces infrared signals corresponding to the original; the functions that operate in radio
frequency (e.g. voice commands and pointers) are not supported.
The remote control has a permanent memory, so it does not lose its settings even if there are no batteries in it.
The remote control and batteries should not be exposed to excessive heat such as sunlight, fire
or the like.
The product is not a toy. Keep out of reach of children or domestic animals.
The remote control requires 2 new 1.5V AAA/LR03 alkaline batteries, not included in the
package. Insert with the correct polarity as shown in figure.
DO NOT use rechargeable batteries.
BATTERIES TEST: Press and hold the
continuously until the button is released. If the light is off or blinks, the inserted batteries are low,
therefore they need replacement.
Do not leave exhausted batteries inserted, as liquid may leak and damage the remote control
If the remote control can not control the TV correctly, it is essential to set a specific code, it matched.
Identify the specific code and set it into the remote control using one of the following ways:
Keep this booklet for future reference
factory with a specific code.
to the chapter ACTIVATION OF REMOTE CONTROL.
SONY

SAFETY WARNINGS

INSERTING THE BATTERIES

5
button and check that the LED remains on

ACTIVATION OF REMOTE CONTROL

SMARTPHONE
TABLET - WEB
TLC03+
digital television sets.
MANUAL
SEARCH