MELICONI TLC01 Quick Start Manual

Remote control for TV sets SAMSUNG ready to use
Thank you for choosing a Meliconi remote control.
This remote control, after inserting the batteries, is normally ready for use as it is already set at the
The TLC01 remote control is designed to command a
The MELICONI remote control reproduces infrared signals corresponding to the original; the functions that operate in radio
frequency (e.g. voice commands and pointers) are not supported.
The remote control has a permanent memory, so it does not lose its settings even if there are no batteries in it.
The remote control and batteries should not be exposed to excessive heat such as sunlight, fire
or the like.
The product is not a toy. Keep out of reach of children or domestic animals.
The remote control requires 2 new 1.5V AAA/LR03 alkaline batteries, not included in the
package. Insert with the correct polarity as shown in figure.
DO NOT use rechargeable batteries.
BATTERIES TEST: Press and hold the
continuously until the button is released. If the light is off or blinks, the inserted batteries are low,
therefore they need replacement.
Do not leave exhausted batteries inserted, as liquid may leak and damage the remote control
If necessary it is possible to completely reset the remote control and bring it back to the initial conditions.
WARNING : All user settings will be lost. Operate as follows:
• On the MELICONI remote control press and hold the
• Enter the code 0100.
• Three final flashes indicate that the operation has been completed successfully.
Keep this booklet for future reference
factory with a specific code.
SAMSUNG

SAFETY WARNINGS

INSERTING THE BATTERIES

5
button and check that the LED remains on

RESET THE REMOTE CONTROL

button until the LED lights up; release.
TLC01
digital television sets.