Hp-Ux Systems; Hp Servers And Workstations-Hp-Ux 11.X; Introduction; Determining The Scsi Id - HP 330834-B21 - StorageWorks Ultrium 460 Tape Library Drive Module Technical Reference Manual

HP-UX Systems

HP Servers and Workstations—HP-UX 11.x

Introduction

Determining the SCSI ID

Class I H/W Path
=================================================================================
bc 0
bc 1 8
ba 0 8/0
ext_bus 1 8/0/2/0
target 0 8/0/2/0.7
ctl 1 8/0/2/0.7.0 sctl
lan 0 8/0/20/0
ba 1 8/16
tty 0 8/16/4
ext_bus 2 8/16/5
Note HP-UX 10.x is only supported by Generation 1 Ultrium drives.
Before you install your tape drive log on to the HP web site,
and download the latest hardware enablement patch bundle for your
operating system. This ensures that you will have the correct device driver for
your tape drive.
Before you configure your system to support your new HP Ultrium drive, you
need to determine what SCSI ID to use. The SCSI ID must be unique for each
device attached to the SCSI bus. To list the existing devices, use the following
command:
% /sbin/ioscan -f
The output of this should look similar to the following example:
Driver S/W State H/W Type
root CLAIMED
bc CLAIMED
GSCtoPCI CLAIMED
c720 CLAIMED
tgt CLAIMED
CLAIMED
btlan3 CLAIMED
bus_adapter CLAIMED
asio0 CLAIMED
c720 CLAIMED
Description
BUS_NEXUS
BUS_NEXUS Psudo Bus Converter
BUS_NEXUS GSCtoPCI Bridge
INTERFACE SCSI C895 Ultra2 Wide LVD
DEVICE
DEVICE Initiator
INTERFACE PCI(10110019) -- Built-in #1
BUS_NEXUS Core I/O Adapter
INTERFACE Built-in RS-232C
INTERFACE Built-in SCSI
2
,
www.hp.com
HP-UX Systems 13