Mounting An Internal Scorpion 40; Figure 8. Mounting A Drive; Figure 9. Mounting Holes For Scorpion 40 Drive In 3.5-Inch Configuration (Without Mounting Brackets) - Seagate STD2401LW-S Product Manual

20

Mounting an internal Scorpion 40

Mounting the drive in a 3.5-inch drive bay
You can install your Seagate internal DDS drive
horizontally or vertically (on its side). Figure 8 shows a
3.5-inch drive being installed in a typical system using
side mounting screws.
Mount the drive in a 3.5-inch drive bay and secure it
using two M3.0 metric screws on each side of the
drive. Do not use non-metric screws or screws longer
than 4 mm or you may damage the drive. As shown in
Figure 9 below, the 3.5-inch drive has four screw holes
on the bottom and five on each side.
41.3 mm
(1.63 in)
13.0 mm (0.51 in)
2 places
5.0 mm (0.196 in)
2 places
M3.0 x 4 deep min.
(10 places)
90.0 mm
(3.54 in)
2 places
60.0 mm
(2.36 in)
2 places
21.0 mm (0.83 in)
2 places
41.2 mm
(1.62 in)
Side View
Note: Tolerance for all dimensions is 0.25mm (0.01 in)
Figure 9. Mounting holes for Scorpion 40 drive in 3.5-inch configuration (without
mounting brackets)
Scorpion 40 DDS-4 Product Manual, Version A
3.8 mm (0.15 in)
M3.0 x 4 deep min.
6.0 mm 101.6 mm
(0.24 in)
Bottom View

Figure 8. Mounting a drive

101.6 mm
(4.00 in)
94.0 mm
(3.70 in)
(4 places)
70.0 mm
(2.75 in)
31.0 mm
(1.22 in)
(4.00 in)
146.0 mm
(5.75 in)