Table of Contents
Advertisement
Installation
Installation
Introduction
Unpacking and Inspection
Installing an internal Scorpion 40
This chapter explains how to install the Scorpion 40 drive. Some of the information
relates to all models; other information is specifically aimed at either the internal or
external models. The following paragraphs briefly outline the organization of this
chapter.
Unpacking and Inspection: contains general information that you should read
before installation.
Installing the Internal Drives: describes how to install the 3.5-inch internal
drive and the 3.5-inch drive with 5.25-inch mounting rails and bezel.
Installing the External Drive: describes how to install the external subsystem.
Although drives are inspected and carefully packaged at the factory, damage may
occur during shipping. Follow these steps while unpacking the drive.
1.
Visually inspect the shipping containers and notify your carrier immediately of
any damage.
2.
Place shipping containers on a flat, clean, stable surface; then carefully remove
and verify the contents against the packing list.
If parts are missing or the equipment is damaged, notify your Seagate
representative.
3.
Always save the containers and packing materials for any future reshipment.
Internal drive installation involves three main steps:
1.
Configuring the drive
2.
Mounting the drive
3.
Connecting the power and interface cables
15
3
Hide quick links:
Advertisement
Table of Contents
