How To Use The Appliance - GEHA A4 BASIC Manual

HOW TO USE THE APPLIANCE

• We do not recommend laminating any type of self-developing photo.
• Any photo to be laminated must be dry before processing.
• Do not laminate any documents that appear thick or heavy, as they will get stuck in
the laminator. If this occurs, please contact your local service centre for servicing.
• This product bonds the laminate sleeve to the items processed. It is a permanent
seal and cannot be removed.
• We do not recommend laminating any collector's items of value or any item you
may wish to remove at a later date. Do not attempt to laminate coins or thicker items.
1 Pouch exit
2 ABS Anti Blockage button
3 Pouch entrance
4 Sliding switch
5 Operating indicator for hot/cold lamination
6 OFF – turn off
7 COLD – cold lamination
8 HOT – hot lamination
1. If you wish to use the device for hot laminating, push the sliding switch to the right.
The red indicator light is on.
2. When the blue light comes on, the machine is ready for hot pouches lamination (fig. 1).
The warm-up time takes approx. 3-5 minutes.
3. Place the item to be laminated into the laminating sleeve, centring it within the sleeve.
Please make sure your document or picture is positioned as close to the sealed
edge as possible.
• The laminator does not require the use of a carrier in order to operate.
• The laminator can laminate pouches from 80 microns to 100 microns.
It works with most types of heat-sealing laminating pouches.
4. If you want to use cold pouches when the laminator is in cold condition, please push
the sliding switch to the left position, the Red light comes on at the same time,
and it is ready to laminate with cold pouches.
8
Fig. 1