Skoda CAR RADIO BOLERO - FOR SUPERB Manual page 10

8 Basic setting
Irrespective of which radio station is heard, an additional receiver part in the unit
ensures that a traffic information station can always be received as long as the traffic
information function is switched on.
The readiness of the traffic information function is displayed by "TP" at the top right
in the display.
If no traffic information station can be received because, for example, radio recep-
tion is interrupted in general, "No TP" will be displayed instead of "TP". Remember
that car parks, tunnels, high buildings or mountains can interrupt the radio signal
up to the total loss of reception.
Incoming traffic announcement
When a traffic announcement is being received, a pop-up window will open.
If you wish to interrupt the transmission of the traffic announcement, press on the
function key in the pop-up window Traffic announcement. The traffic infor-
Cancel
mation function remains available and a following traffic announcement is made
again while the audio mode is in operation. Pressing the function key
will switch off the traffic information function permanently.
TP deactivated
Traffic information memory
Automatic recording of traffic reports
If the traffic information function is switched on and a traffic information station is
received, the incoming traffic reports will be recorded, as long as the ignition is
switched on. This way you are informed at any time of the current traffic situation,
even if you have your radio switched off for a lengthy period while driving.
If the vehicle is not in use (ignition off) while a traffic information station is received
and the traffic information function is switched on, incoming traffic reports from
this station are recorded for two hours.
When switching the ignition off the current traffic information station is displayed
for about five seconds, from which the next 65 minutes of traffic reports will be
recorded. During this display of five seconds, you can select another traffic infor-
mation station using the arrow keys on the unit, which will be recorded.
If, when the vehicle is not in use, the reception of the set traffic information station
is too poor because of external influences, it will automatically search for another
traffic information station.
A maximum of nine traffic announcements with a total length of up to four minutes
can be recorded. The oldest traffic report will always be overwritten if the memory
is full.
TIM recording times
You also have the possibility to set two TIM recording times, to which the unit will
also record traffic reports when the vehicle is not in use. Then the radio starts
according to the set TIM recording time with the recording of all the incoming traffic
reports on the set traffic information station.
For example, when you drive your vehicle to work everyday at a certain time, only
enter the approximate start time. The radio starts with the recording at the set start
time and ends the recording 65 minutes afterwards. In this way, before you begin
your journey, you can retrieve the last traffic reports and tune into the current traffic
situation of the distance to be driven.
Note
•
In case of a message of over four minutes long, the beginning is overwritten.
•
If the vehicle has not been used for more than three days, no further traffic
reports are recorded, in order to stop the vehicle battery from running down.
Playing traffic reports
– Press on the button , in order to listen to the stored traffic
INFO
reports. The play function starts with the last recorded traffic report
and runs through to the oldest recorded traffic report.
– Press on the button , in order to switch to the beginning of the

currently heard traffic report.
– In order to skip a traffic report, press on the button .
