Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for CDA CTE62SS
Summary of Contents for CDA CTE62SS
- Page 1 CTE62SS/ CTE92SS Extractor Installation, use and maintenance www.cda.co.uk...
-
Page 2: Table Of Contents
Contents: Important Safety information Operation Extractor lighting & Operating modes Ducting and ventilation Mains electrical connection & Information Product dimensions Positioning your extractor Installation Care and Maintenance (Grease & Carbon Filters) CDA Customer Care... -
Page 3: Important
Appliance information Please enter the details on the appliance rating plate below for reference, to assist CDA Customer Care in the event of a fault with your appliance and to register your appliance warranty. Appliance model Serial number... - Page 4 EU Declarations of Conformity This appliance has been designed and manufactured to comply with all applicable UK and EU legislation, Low voltage Directive, 2014/35/EU Electromagnetic compatibility Directive, 2014/30/EU ErP Directive, 2009/125/EC RoHS Directive, 2011/65/EU and has been marked with the following symbols IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EU DIRECTIVE 2012/19/EU.
-
Page 5: Safety Information
Safety Information Under no circumstances should the extractor be connected to any gas ventilation system, flue system or hot air ducting system. Do not vent the extractor into an attic or loft space. Only house the extractor in rooms with adequate ventilation. -
Page 6: Operation
Operation Cooker hood controls Control Panel is shown in Figure 1, for your reference it is also shown below: Fig 1. The control panel is equipped with rocker switches to control your appliance. You can use the switches once the retractable front panel is extended. - Page 7 The lighting on your extractor uses energy efficient LED technology and is designed to last the lifetime of the product. If the LED system malfunctions, please contact CDA Customer Care. The LED units must only be replaced by a competent appliance service engineer.
-
Page 8: Ducting And Ventilation
Ducting and Ventilation For best performance and lowest noise output, we recommend the use of 120mm ducting. It is possible to use 100mm ducting, but this will reduce performance. In general, the less ducting you use (i.e. distance and bends) the more efficient your extractor will be. -
Page 9: Mains Electricity Connection
The wire which is coloured brown must be connected to the terminal marked L (Live) or coloured red or brown. If the mains cable of this appliance is damaged, it must only be replaced by a CDA approved service engineer, agent, or other suitably qualified person. Instruction Manual | 9... -
Page 10: Electrical Information
IMPORTANT – ONLY USE A 3 AMP FUSE The use of a 13A fuse can cause internal wiring damage which will not be covered under the CDA warranty. It is a requirement that you must be able to isolate the extractor from the mains electrical supply after installation. -
Page 11: Product Dimensions
Product Dimensions CTE62SS Fig 5. CTE92SS Fig 6. Instruction Manual | 11... -
Page 12: Positioning Your Extractor
HOB, THE MINIMUM DISTANCE BETWEEN THE HOB AND EXTRACTOR MUST BE AT LEAST 650mm. Important: The CTE62SS is intended for use above a hob of width 60cm or less. The CTE92SS is intended for use above a hob of no more than 90cm. -
Page 13: Installation
Installation This extractor is designed to be mounted into a bridging unit or similar and screwed directly to a supporting shelf, with its lower surface sitting 140mm from the bottom of the unit, as shown in the following image: Ducting Dia. -
Page 14: Care And Maintenance (Grease & Carbon Filters)
Care and Maintenance Regular maintenance and cleaning of the appliance will ensure trouble- free operation of the cooker hood and extend its life. Especially make sure that the grease filter and activated charcoal filter are replaced according to manufacturer’s recommendations. ... -
Page 15: Cda Customer Care
Contacting CDA Customer Care A: Customer Care Department, The CDA Group Ltd, Harby Road, Langar, Nottinghamshire, NG13 9HY T: 01949 862 012 F: 01949 862 003 E: customer.care@cda.co.uk W: www.cda.co.uk Instruction Manual | 15... - Page 16 For more information please contact: 01949 862 010 sales@cda.co.uk The Sales Department on or email Customer Care Department. The CDA Group Ltd, Harby Road, Langar, Nottinghamshire, NG13 9HY 01949 862 012 F: 01949 862 003 E: customer.care@cda.co.uk www.cda.co.uk...
Need help?
Do you have a question about the CTE62SS and is the answer not in the manual?
Questions and answers