Shark Clean & Empty PowerDetect Owner's Manual page 6

CHARGING YOUR LI-ION BATTERY
Prior to first use, charge the battery completely. A full charge takes approximately 6 hours.
RUNTIMES PER FULLY CHARGED BATTERY
With a full charge, the unit will have up to a 70-minute runtime. Visit support.sharkclean.co.uk
online for more information.
LED BATTERY POWER AND CHARGING INDICATORS
Charging
LED on the battery pack will pulse yellow when reaching 0-75% charge.
LED on the battery pack will pulse green from 75% - 100% charge.
White LED the battery pack is fully charged.
NOTE: Full charge takes approximately 6 hours.
Additional Notes
1. LEDs turn off once the battery is fully charged.
2. Unit will not power on when charger is connected.
In Use
Full Mid
Charge Charge
RECYCLING THE LI-ION BATTERY
When the Shark Li-ion battery needs to be replaced, dispose of it or recycle it in accordance
with local ordinances or regulations. In some areas, it is illegal to place spent lithium-ion
batteries in the standard rubbish bin. Return spent batteries to an authorised recycling centre
or to the retailer for recycling. Contact your local recycling centre for information on where to
drop off the spent battery.
NOTE: The Shark battery, like all lithium-ion batteries, will naturally decrease in capacity over time from the 100% capacity of
a new battery.
10
s h a r kc l e a n . c o . u k
NOTE: Battery consumption will vary depending on the
mode being used:
ECO – Maximum Runtime, saves battery power
AUTO – Optimises suction and power for maximum
cleaning
BOOST – Maximises suction. Uses the most batter power
Low No
Charge Charge
CHARGING YOUR LI-ION BATTERY
BATTERY REMOVAL
To remove the battery from the vacuum,
press the release button on the battery
and slide out of the handle compartment.
To reinstall, slide the Battery back into the
compartment until it clicks into place.
CONTACTS
UPRIGHT DOCK CHARGING IP3000 SERIES
Charge the unit by placing it on the dock. Make
sure the contacts on the wand are aligned
with the contacts on the charging post.
When charging is complete and you need
to use the unit again, lift it off the dock.
NOTE: When the unit is docked properly, the charging lights on the battery will blink, indicating that charging has begun.
NOTE: The main unit comes with a partial charge. For maximum runtime, charge fully before first use (approximately 6
hours). Leaving the unit plugged in will not damage battery life.
CHARGING SLEEVE
To charge the battery, remove it from the
vacuum and insert into the charging sleeve.
Once the battery is showing as fully charged
reinsert into the handle compartment on the
vacuum (see charging indicators on previous
page)
s h a r kc l e a n . c o . u k
11