Table of Contents
Advertisement
16. Appendix I
16.5.4. Read TOC (0x43)
This command shall only be supported in DR mode.
5.4.1.
Returned Data (20 bytes)
00 12 01 01 00 14 01 00 00 00 00 00 00 14 AA 00 00 04 B0 00
16.5.5. Mode Sense/Select Page Code 0x3C
DR Mode Entry/Exit Page
Bit
7
Byte
Reserved
Reserved
0
1
2
3
4
5
DREnable: This bit reflects the status of the DR mode. When the drive enters DR mode, DREnable bit will be set to
1. This bit shall be reset to zero when the drive exits the DR mode. A Mode Select of Page Code 0x3C with setting of
DREnable bit will force the drive to enter DR mode. With DREnable bit set to zero, the drive will exit the DR mode.
Setting this bit to 1 when the tape is not write-protected shall be rejected with a Check Condition of Illegal Request
(0x05) and ASC of 26h and ASCQ of 02h.
16.6. Reset Handling
While in DR mode, a SCSI reset shall not take the drive out of DR mode. A powered cycle will take the drive out of
DR mode and return the drive to normal operation.
16-2
6
5
4
Page Length=04h
Reserved
3
2
Page Code=3Ch
Reserved
Reserved
Reserved
SONY AIT-2 Turbo drive SDX-550V series Ver.1.0
1
0
DREnable
Advertisement
Table of Contents
