Table of Contents
Advertisement
READ BUFFER
6.14. READ BUFFER 3Ch
Bit
7
Bite
0
1
Logical Unit Number
2
3
(MSB)
4
5
6
(MSB)
7
8
9
Unused (00b)
READ BUFFER is used in conjunction with WRITE BUFFER as a diagnostic function for testing the buffer and the
SCSI bus integrity of the drive. A REWIND command should be sent to the drive after WRITE/READ BUFFER
diagnostic testing to return to normal operation.
Note: This command may not be used to recover data that is buffered within the drive. If the drive receives a READ
BUFFER without having had a prior WRITE BUFFER command, only the four byte header will be returned. There is
no available data to return, as the drive writes any buffered data to tape prior to accepting either a READ BUFFER or
WRITE BUFFER for the first time.
Mode: The drive supports the following values within this field. If any other value is set, the drive will terminate the
command with a CHECK CONDITION status and an ILLEGAL REQUEST sense key set.
Combined Header and Data Mode - in this mode, the drive returns a four-byte header followed by the data bytes.
The drive terminates the DATA IN phase when Allocation Length bytes of header plus data have been transferred or
when the header and all available data have been transferred to the initiator, whichever is less. The four-byte READ
BUFFER header is followed by data bytes from the drive's data buffer.
Bit
7
Byte
0
1
(MSB)
2
3
Available Length: specifies the total number of data bytes that are available in the target's data buffer. This number
is not reduced to reflect the Allocation Length nor is it reduced to reflect the actual number of bytes written using the
WRITE BUFFER command. Following the READ BUFFER header, the target will transfer data from its data buffer.
Data Mode- in this mode, the DATA IN phase contains buffer data only.
Descriptor Mode- In this mode a maximum of four bytes of READ BUFFER descriptor information are
returned. The drive returns the descriptor information for the buffer specified by the Buffer ID. In this mode,
the drive does not reject the valid Buffer IDs with a CHECK CONDITION status but returns FF6800h when
Buffer ID is set to 0, 1000000h when Buffer ID is set to 1 in the READ BUFFER descriptor.
SONY AIT-2 Turbo drive SDX-550V series Ver.1.0
6
5
4
Operation Code (3Ch)
Reserved
Allocation Length
Table 6-58: READ BUFFER Mode values
Mode
Description
0000b
Combined Header and Data
0010b
Data
0011b
Descriptor
1010b
Echo Buffer
1011b
Echo Buffer Descriptor
Table 6-59: READ BUFFER Header
6
5
4
Available Length
3
2
Buffer ID
Buffer Offset
Reserved
3
2
Reserved
6.Command Specification
1
0
Mode
(LSB)
(LSB)
Flag
Link
1
0
(LSB)
6-69
Advertisement
Table of Contents
