Table of Contents
Advertisement
REQUEST SENSE
6.21. REQUEST SENSE 03h
Bit
7
Byte
0
1
Logical Unit Number
2
3
4
5
Unused (00b)
The REQUEST SENSE command requests that the target transfer sense data to the initiator.
The Sense Data will be valid for a CHECK CONDITION or RESERVATION CONFLICT status returned on the
previous command. The Sense data will be preserved by the target until retrieved by the REQUEST SENSE
command or until the receipt of any other command from the same initiator. The 28 bytes of Sense data are cleared
upon receipt of any subsequent command to the logical unit, including another REQUEST SENSE.
If the drive receives an unsolicited REQUEST SENSE, then it returns Sense Data with the File-mark, EOM and the
appropriate values in the Additional Sense Code/ Additional Sense Code Qualifier fields. These fields are only set if
the drive is currently logically positioned at BOM/P, EOM , EOD, or after a File-mark or after a Set-mark. The Host is
required to know what the current direction of tape motion is and, therefore to know whether the logical position at a
File-mark or Set-mark is either on the BOT or EOT side of that mark.
The positional information provided reflects the logical position of the drive. The drive returns information based on
the data still in its buffer as well as the data on tape.
The REQUEST SENSE command does not cause the drive to flush its buffered data to tape. Therefore, if the Host
requires the exact physical positioning of the media, it should precede the REQUEST SENSE with a WRITE
FILEMARKS command with the number of File-marks field = 0 and with the immediate bit set to ZERO. This
command will force the drive to flush any currently buffered data to tape. A subsequent REQUEST SENSE will
return the initiator the actual physical (and logical) position of the drive.
Note: The drive will only maintain valid positional information on normal operating commands. If the SEND
DIAGNOSTIC or READ/WRITE BUFFER commands are sent to the drive, valid positional information will not be
returned in response to an unsolicited REQUEST SENSE.
Allocation Length: The Allocation Length specifies the maximum number of sense bytes to be returned. The drive
terminates the transfer when the Allocation Length bytes have been transferred or when all available sense data has
been transferred to the Host, whichever is less.
The returned sense information has the following format:
SONY AIT-2 Turbo drive SDX-550V series Ver.1.0
6
5
4
Operation Code (03h)
Allocation Length (1Ch)
6.Command Specification
3
2
Reserved
Reserved
Reserved
Reserved
1
0
Flag
Link
6-83
Advertisement
Table of Contents
