3. Installation
DIP SW 6
OFF
Disable Periodic Cleaning Request
ON
Enable Periodic Cleaning Request
Data Compression ON Switch
3.1.1.
Data compression can be selected by DIP switch.
DC Control-1
DC Control-2
OFF
OFF
ON
ON
Legacy Power Connector
3.1.2.
The Legacy power connector is illustrated as Figure 3-4.
SATA Interface Connectors
3.1.3.
Figure 3-5 illustrates SATA Signal/Power connectors and table 3-3 shows the assignments for the pins of the
connectors.
Pin
P15
SATA Power Connector
Caution!: DO NOT USE both power connections (Legacy Power Connector and SATA Power Connector) at the
same time. Doing so will result in drive failure.
3-2
Table 3-2: Periodic Cleaning Request (Refer to 4.5.1.2)
OFF
Compression disabled at power-on. The host is allowed to control
compression.
ON
Compression disabled at power-on. The host is not allowed to control
compression.
OFF
Compression enabled at power-on. The host is allowed to control
compression.
ON
Compression enabled at power-on. The host is not allowed to control
compression.
Figure 3-3: Data Compression Switches
4
3
5V
GND
Figure 3-4: Legacy Power Connector
Figure 3-5: SATA Interface Connectors
Definition
Definition
2
1
GND
12V
Pin
Pin
P1
S7
SATA Signal Connector
SONY AIT-1 Turbo drive SDX-470V series Ver.1.0
Pin
S1