Descaling; Legal Notice - Gaggia SUP 020 Operating Instructions Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 20
30
holding it by the handle provided and
pushing the «PRESS» button. Use hot
water only, without detergents, to clean
the dispensing unit.
Make sure that there are no coffee
residues on the two steel filters. You may
remove the upper filter by unscrewing
the plastic pin with the wrench provided
(19).
• Thoroughly wash and dry all the parts of
the dispensing unit.
• Replace the filter and use the wrench
provided to tighten the plastic pin firmly
into place.
• Thoroughly clean the machine
compartment.
Holding the dispensing unit by its
handle, fit it back securely into place
inside the compartment.
• Then close the door and set the dregs
box and drip tray back into place.

11 DESCALING

Scale forms while the machine is in use; it
is necessary to remove scale every 3-4
months of use or whenever you observe a
decreased flow of water.
If you wish to descale the
machine yourself, you may use
any commercially available non-toxic,
non-harmful descaling agent for
coffee machines.
Warning! Never use vinegar as a
descaling agent.
• Mix the descaling agent with water as
directed on the package and pour the
solution into the water container.
DESCALING - LEGAL NOTICE
• Turn on the machine by means of the
power switch (7).
• Position the steam tube (15) over the drip
tray.
Empty the contents of the water
container at intervals (one cup at a time)
by turning the steam knob (17)
counterclockwise; turn the knob (17)
clockwise to cut off flow.
• During each interval, allow the descaling
agent to act for about 10-15 minutes,
switching off the machine by setting the
power switch (7) to -0-.
• When all of the descaling agent has been
used up, rinse out the water container
and fill it with fresh water.
• Turn on the machine by means of the
main switch.
Empty out 2/3 of the water in the
tank by turning the steam knob (17)
counterclockwise; turn the knob (17)
clockwise to cut off flow.
• Let the machine heat up and empty out
the water remaining in the tank by turning
the steam knob (17) counterclockwise;
turn the knob (17) clockwise to cut off
flow.
Should you use a descaling
agent other than the one
recommended you are advised in any
case to follow the manufacturer's
directions on the package.

12 LEGAL NOTICE

• The present operating instructions
contain all information necessary to
u s e
t h e
m a c h i n e
understand its functions, and carry
c o r r e c t l y,

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents