F-SECURE CLIENT SECURITY 9.00 Administrator's Manual page 164

164 | F-Secure Client Security | Modifying prodsett.ini
[ES_Setup.DLL]
Debug=0 | 1
InstallMode=0 | 1
[FWESINST.DLL]
RequestInstallMode=1
Debug=0 | 1
InstallMode=0 | 1
[FWINST.DLL]
RequestInstallMode=1
Debug=0 | 1
InstallMode=0 | 1
InstallDC=0 | 1
Settings for the installation of e-mail scanning
2 = Install this component if there is no existing version
of it installed, or if the same or an older version exists.
0 = Do not generate debug information (default).
1 = Write debug information into the debug log during
installation and uninstallation.
0 = Do not install this component (default).
1 = Install this component, except if a newer version
already exists.
Settings for internal common component FWES.
0 = Install this component as defined in the
InstallMode setting.
1 = Install this component if newer, or not installed
(default).
2 = Install this component if there is no existing version
of it installed, or if the same or an older version exists.
0 = Do not generate debug information (default).
1 = Write debug information into the debug log during
installation and uninstallation.
0 = Do not install this component (default).
1 = Install this component, except if a newer version
already exists.
Settings for Client Security - Internet Shield
0 = Install this component as defined in the
InstallMode setting.
1 = Install this component if newer, or not installed
(default).
2 = Install this component if there is no existing version
of it installed, or if the same or an older version exists.
0 = Do not generate debug information (default).
1 = Write debug information into the debug log during
installation and uninstallation.
0 = Do not install this component (default).
1 = Install this component, except if a newer version
already exists.
0 = Do not install Dial-up Control (default).