Digilin OPTIFLEX Installation Manual

OPTIFLEX - Linear Lighting Systems
Installation Guide
CAUTION
• Do not use impact force when installing strip.
• Do not twist luminaire.
• Observe minimum bend diameter.
• Do not bend the first or the last sections of the luminiare.
• Installation should only be performed by a qualified professional.
• Install in accordance with all appropriate wiring standards.
• DALI is not SELV and needs to be wired accordingly.
• Never connect a LED luminaire to a driver that is powered. Doing so may result in damage to the LED.
• Always make sure the output voltage range and output current of the LED driver match the requirements of the
LED luminaire. Failure to do so may result in damage to both the driver and the luminaire.
• The light source contained in this luminaire shall only be replaced by the manufacturer, specified service agent or
a similar qualified person.
• Do not install under mechanical stress.
• Allow for expansion due to changes in temperature.
• Please be aware that while the system has a very long operational life, faults may occur, and provision needs to
be made for maintenance.
• Always turn off power before working on luminaire.
www.digilin.com.au
+617 3899 1267
ABN 76 634 301 376
Document Revision: 250303 - Installation Guide OptiFlex
Product specifications are subject to change without notice
1 of 4
©2025 Digilin Technologies