Digilin Edge 20 Installation Manual

Edge 20 – LED Lighting Profile
Installation Guide

Notes

Install in a dry sheltered position
•
Profile is not sealed. Do not install where water or high humidity may be present without further protection.
•
Installation should only be performed by a qualified professional
•
Install in accordance with all appropriate wiring standards
•
DALI is not SELV and needs to be wired accordingly
•
Never connect a LED fitting to a driver that is powered. Doing so may result in damage to the LED.
•
Always make sure the output voltage range and output current of the LED driver match the requirements of the
•
LED fitting. Failure to do so may result in damage both the driver and fitting.
The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.
•
Do not install under mechanical stress.
•
Allow for expansion due to changes in temperature.
•
Please be aware that while the system has a very long operational life, faults may still occur, and provision needs to be made for maintenance.
•
Always turn off power before working on fitting.
•

Specifications

Dimensions
Length
Weight

Wiring Diagram

digilin.com.au
+617 3899 1267
U n i t s
20 x 20 mm
Custom
200 g/m
Document Rev: 2.1 - 10 August 2021
Product specifications are subject to change without notice
©2021 Digilin Technologies
Page 1 of 2