Summary of Contents for Hoshizaki Ice Mate SRM-270WB
Page 1
MODULAR RHOMBIC CUBER INSTRUCTION MANUAL SRM-270WB SRM-200WB SRM-450WB-S SRM-650WB-S SRM-650WB-S-14 SRM-270WB SRM-200WB SRM-450WB-S SRM-650WB-S SRM-650WB-14 ●This booklet is an integral and essential part of the product and should be kept and Preserved by the user. ●Please read carefully the guidelines and warnings contained herein as they are intended to provide the installer / user with the essential information for the proper installation and continued safe use and maintenance of the product.
IMPORTANT SAFETY INFORMATION Throughout this manual, notices appear to bring your attention to situations which could result in death, serious injury or damage to the unit. WARNING Indicates a hazardous situation which, If not avoided, could result in death or serious injury. CAUTION Indicates a hazardous situation which, If not avoided, could result in minor or moderate injury.
Ⅰ. INSTALLATION INSTRUCTIONS 1.CONSTRUCTION Top Panel Control Box Power Switch Left Panel Name Plate Front Panel [SRM-270WB] [SRM-200WB] [SRM-400WB] Control Box Top Panel Power Switch Left Panel Front Panel Name Plate [SRM-650WB-S] [SRM-650WB-S-14]...
3)Remove the protective film from the exterior. If the icemaker is exposed to the sun or to heat, remove the film after theicemaker cools. 4)Remove the front panel and top panel, then remove accessories from the machine room. 5)Remove the package of accessories. Check the contents according to "2.ACCESSORIES". 4.LOCATION WARNING This ice maker is not intended for outdoor use.
6.ELECTRICAL CONNECTIONS WARNING THIS APPLIANCE MUST BE EARTHED This icemaker requires an earth that meets the national and local electrical code requirements. To prevent possible severe electrical shock to individuals or extensive damage to the unit, install a proper earth wire to the icemaker. Disconnect the main power supply before any maintenance, requires or cleaning is undertaken.
II.OPERATING INSTRUCTIONS CAUTION Do not put your hands into the the ice drop space or water tank. The ice on the evaporator may drop off , a hard block of ice may suddenly break down, or pump motor may suddenly start-up, resulting in injury. Water Tank Ice drop space NOTICE...
1)Unplug the icemaker or disconnect the power supply. 2)Close the water supply tap, and remove the inlet hose. 3)Remove all ice from the storage bin, and clean the bin. 4)Ask for draining of the icemaker by professional qualified personnel. Ⅲ.MAINTENANCE 1.CLEANING WARNING Before carrying out any cleaning or maintenance operations, unplug the icemaker from the electrical supply...
Page 10
●Please wash the work clothes you wear when handling agents. About agent ■use the agent recommended by the manufacturer. ■Please contact Hoshizaki sales company about agents. ■If you have any other questions, please contact the agents manufacturer. ■Please prepare the agent according to the following proportions:...
Page 11
■Cautions ●Regarding the order of use of the agents, please sterilize after washing.Wrong order or using only one of them will reduce cleaning and disinfection effectiveness. ●Do not eat, drink or smoke while using the agent. ●Please stir the agent and room temperature water fully to dissolve and pour it into the equipment. ●Slowly pour the dissolved agent into the sink.
How to remove the front panel and water tank ■ STEP1 STEP2 Display Hand Nut Water Tank How to remove the water tank: How to remove the front panel: STEP1:Remove the hand nuts on both sides of the STEP1:Raise the front panel up to a certain water tank;...
Page 13
Fault Probable Cause Processing method The power switch is not allocated to the "ON" Switch the power switch. position. The connector of the power cord is loose. Fasten the power cord connector. The voltage is too high or too low. Check and use the proposed voltage.
Warranty repair should be completed by an approved manufacturer dealer or service agency using genuine manufacturer components. To obtain full details of your warranty and the approved service agency, please contact your dealer / supplier or the nearest manufacturer's service offi ce. Repair Hotline: 400-720-6910 Email: service@hoshizaki.com.cn SPECIFICATION Model SRM-270WB SRM-200WB...
Page 15
SPECIFICATION Model SRM-650WB-S-14 Type Water-cooled, rhombic ice cube Power Supply 1 phrase, 220~240V 50Hz Electrical Consumption 2035W Ice Production Per 24h 650kg(ambient10°C, water10°C) Dimensions 1220mm(W)*620mm(D)*760mm(H) Refrigerant R404A,1000g Weight New weight:115kg Ambient Temperature 5 - 38°C Water Supply Temperature 5 - 32°C Water Supply Pressure 0.07 - 0.55MPa(0.7~5.5bar)...
Need help?
Do you have a question about the Ice Mate SRM-270WB and is the answer not in the manual?
Questions and answers