Yamaha RX-A3000 Owner's Manual page 138

SOURCE RECEIVER
l
3 Select the operation mode (SOURCE,
RECEIVER or TV mode) for which functions
AV
will be assigned to remote control keys.
1 2 3 4 4
5 6 7 V-AUX • Selecting the SOURCE mode
AUDIO
d
d
1 2 3 4 Press Input selector
PHONO MULTI USB NET In this mode, remote control functions for the selected
DOCK TUNER SIRIUS
[ A ]
input source can be assigned to this unit's remote control.
• RECEIVER mode
l RECEIVER A
Press
In this mode, remote control functions for external
amplifier can be assigned to this unit's remote control.
NOTE
When remote control functions are assigned for this
mode, it may be impossible to operate this unit using
i
ENTER
the remote control.
• TV mode
k
A
Press to enter TV mode.
In this mode, remote control functions for a TV can be
assigned to this unit's remote control.
Remote control functions can be assigned to this unit's
TV
INPUT
remote control keys as follows.
TV VOL TV CH
k
MUTE
Mode
SOURCE
RECEIVER
J1
TV
k
J
1 : Once TV control keys
always be controlled.
k
When TV control keys
specified in SOURCE mode can be controlled when the input
source is selected.
4
to enter SOURCE mode.
to enter RECEIVER mode.
5
Keys
Keys for operating the external
b
A,
components such as SOURCE
g
External component operation
i
Cursor B / C / D / E.
keys
or
Keys for operating this unit such as
g
External component operation
i
Cursor B / C / D / E
keys,
and
w
Numeric keys.
k
TV control keys
are set in TV mode, the TV can
are set in SOURCE mode, the TV
Controlling the remote control to operate various functions
Place this remote control about 2 to 4 in (5
to 10 cm) apart from the remote control of
the external component on a flat surface so
that their infrared transmitters are aimed at
each other and then press iENTER.
"PRES KEY" appears in the display window.
Other remote control
2 to 4 in (5 to 10 cm)
Press a key to which you want to assign the
function.
"START" appears in the display window.
SETUP
6 Press and hold the key you want to program
on the other remote control until "OK"
appears in the display window.
"NG" appears in the display window if learning was
unsuccessful. In this case, start over from step 3.
Other remote control
OK
When you want to program another function, repeat
steps 3 to 6.
Continues to the
En
next page
138