Memory Operation; Memory Storage; Memory Channel Recall - Yaesu FTDX-9000MP Operation Manual

The memory system of the FT
and a wide variety of status information detailed previously. Memories may be grouped into as many as six Memory
Groups, and additionally you get nine pairs of band-limit (PMS) memories along with five QMB (Quick Memory Bank)
memories.
1. Set the Main (VFO-A) band up with all frequency,
mode, and status the way you want to have it stored.
2. Press the A M button (#
rent channel number will start blinking); the contents
of the current memory channel will be shown on the
Sub (VFO-B) display field.
3. Press the MCH/GRP key (#
When you press the MCH/GRP key, the Red LED
imbedded within the switch should light up, indicat-
ing that you are ready to choose a channel into which
to store the data.
Advice
If the Red LED imbedded in the MCH/GRP key
does not light up, check to be sure that the orange lamp
to the right of the CLAR/VFO-B knob (#
illuminated. It it is, press the A/B switch (#
make it go out, then press the MCH/GRP key again.
4. Rotate the CLAR/VFO-B knob to select the memory
channel onto which you wish to store the data. If you
have selected a channel on which data is already stored,
that frequency will appear on the Sub (VFO-B) band's
frequency display field.
5. Press and hold in the A M key for two seconds to
store the frequency and other data into the selected
memory channel. A double beep will confirm that you
have held the A M key in long enough.
1 Press the V/M key (#
Memory mode. A memory channel number will ap-
pear in the multi-panel window.
2. Press the MCH/GRP key (#
The Red LED inside the switch will light up, indicat-
ing that you are ready to recall a memory channel.
Advice
If the Red LED imbedded in the MCH/GRP key
does not light up, check to be sure that the orange lamp
to the right of the CLAR/VFO-B knob (#
illuminated. It it is, press the A/B switch (#
make it go out, then press the MCH/GRP key again.
3. After pressing the MCH/GRP key, you may rotate
the CLAR/VFO-B knob to select the desired
memory channel.
Advice
To work within a particular Memory Group, press and hold
in the MCH/GRP key for two seconds. The imbedded
LED will glow Orange; now press the MCH/GRP key
momentarily, and the LED will change to Red; you mauy
now choose the channel within the selected Memory Group.
FT 9000MP O
9000MP allows storage and recall of up to 99 memories, each storing frequency, mode,
M
EMORY
) momentarily (the cur-
) momentarily.
) is not
) to
M C
EMORY HANNEL
), if necessary, to enter the
) momentarily.
) is not
) to
M
M
EMORY
S
TORAGE
R
ECALL
O
PERATION
V/M Key CLAR/VFO-B Knob
A M Key MCH-GRP Key
CLAR/VFO-B Knob
MCH-GRP Key
V/M Key
Page 117