Operation - Yaesu FTDX-9000MP Operation Manual

FH-2 O
PERATION
The supplied Remote Control Keypad "FH-2" can be used to control the voice memory capability for the SSB/AM/FM
modes, and the contest memory keyer for the CW mode. You can also play back up to 30 seconds of incoming received
audio, as well, for verification of a missed callsign or other purposes. Among the specific capabilities of the FH-2 are:
H Five channels of storage and playback of voice memory (20 seconds each), using your own voice for recording (see
page 95).
H Playback of the last 30 seconds of incoming receiver audio (see page 54).
H On CW, the FH2 provides storage and recall of CW messages for repetitive CQ and contest number transmissions (see
page 108).
Voice Memory/CW Message Memory
Selection Keys (5 Channels)
In the case of Voice Memory, up to 20 seconds of
audio may be stored on each channel.
For CW messages and CW Text messages, up to 50
characters ("PARIS" specification) may be stored
into each channel.
Text Memory Programming Keys
These keys are used for navigation when selecting
text characters for the programming of Contest and
Text memories.
Playback Key
This key replicates the action of the P.BACK
("Playback") switch on the front panel of the trans-
ceiver, and is used for playing back the last 30 sec-
onds of recorded receiver audio.
Page 42
LOCK
ON OFF
LOCK Switch
This switch may be used to lock out the FH-2's keys, to
prevent accidental activation of FH-2 operation.
MEM Key
This key is pressed for the purpose of storing either a
Voice Memory or a Contest Keyer Memory channel's
contents.
DEC Key
When utilizing the sequential contest number capabil-
ity of the Contest Keyer, press this key to decrement
(back up) the current Contest Number by one digit (i.e.
to back up from #198 to #197, etc.).
FT 9000MP O M