Image Is Offset - Xerox Phaser 7760 User Manual

Image Is Offset

Problem
Toner appears to have been pulled off the page and placed about 84 mm (3.3 in.) across
Solution
1.
Verify that the paper you are using is the correct type for the printer. See
and Media on page 3-3.
2.
Verify that the paper is properly loaded in the tray, and the correct paper type is selected in
the
Paper Tray Setup
If the problem continues:
1.
Do one of the following:
■ Tray 1 (MPT): Remove and re-insert the paper.
■ Tray 2-5: Open and close the selected paper tray. The control panel prompts you to
confirm or change the paper type.
2. On the control panel, select
following:
■ Select the correct paper type, and then press the OK button.
■ Select the next lighter type of paper, and then press the OK button.
Note: Paper types from heaviest to lightest are: Extra Thick Card Stock, Thick Card Stock,
Thin Card Stock, Heavy Plain Paper, and Plain Paper.
the page from where it should be.
menu. See Loading Paper
, press the OK button, and then do one of the
Change
Phaser® 7760 Color Laser Printer
4-11
Solving Print-Quality Problems
Supported Paper
on page 3-9.