EINHELL CE-CB 18/254 Li Original Operating Instructions page 17

1. Dab with the textile polishing bonnet on dif-
ferent positions of the paintwork you want to
polish. This will help to distribute any excess
polishing agent over the textile polishing
bonnet and/or over the paintwork you want to
polish.
2. Hold the handle of the equipment fi rmly in
both hands, place the polishing machine onto
the paintwork you want to polish (Fig. 11) and
switch on the equipment by pressing the On/
Off switch (Fig. 1 / Item 3).
3. First work on the large level surfaces such
as the engine hood, boot lid and roof (Fig.
12), then on the smaller surfaces such as the
doors and mudguards (Fig. 13). Guide the
equipment smoothly over the paintwork, exer-
ting no pressure.
4. Switch off the equipment with the On/Off
switch (Fig. 1 / Item 3) before you remove it
from the paintwork you are polishing.
5. For areas which are diffi cult to reach, remove
the textile polishing bonnet from the polishing
disk and process these areas by hand (Fig.
14).
6.4 Polishing the paintwork with the synthetic
polishing bonnet
Note: After the previously applied polishing agent
has dried completely on the paintwork, you can
begin with the polishing. Damp polish will be sme-
ared by the synthetic polishing bonnet.
1. Replace the textile polishing bonnet with the
synthetic polishing bonnet. Make sure that
the synthetic polishing bonnet is free of any
foreign bodies.
2. Remove the polish layer in the same order in
which you applied the polishing agent to the
paintwork. Be sure to follow the instructions
issued for using the waxing and polishing
agent.
7. Replacing the power cable
Danger! Information on the charger
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
Anl_CE_CB_18_254 Li_SPK13.indb 17 Anl_CE_CB_18_254 Li_SPK13.indb 17
GB
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the battery pack before starting
any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
•
Wash the polishing bonnets only by hand and
let them air-dry.
•
When the polishing machine is not being
used it should be stored face up with the po-
lishing bonnet removed so that the polishing
disk can dry and retain its original shape.
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
- 17 -
07.04.2025 11:05:37 07.04.2025 11:05:37