Removal And Replacement Of Parts; Covers And Panels - Vulcan-Hart VSX3E Service Manual

VSX SERIES STEAMER - REMOVAL AND REPLACEMENT OF PARTS

REMOVAL AND REPLACEMENT OF PARTS

COVERS AND PANELS

WARNING: DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
Right Side Panel
1. Remove screws from the bottom of the panel.
2. Slide panel down to clear the top cover.
3. Reverse procedure to install.
(Gas Model Shown)
Top Cover
1. Remove screws from the top rear of cover. If
steamer is a gas model, follow steps 1A and 1B.
A. Remove the screws at the base of the
exterior flue housing and lift off.
B. Remove the screws that secure the flue to
the tank and lift it off.
2. Push up on the rear of the cover and slide the
top cover forward to clear the front edge.
3. Lift the cover off the cabinet.
4. Reverse procedure to install.
Left Side and Rear Panel
1. Remove the top cover screws an disconnect the
utilities.
Page 6 of 40