Door - Vulcan-Hart VSX3E Service Manual

VSX SERIES STEAMER - REMOVAL AND REPLACEMENT OF PARTS

DOOR

WARNING: DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
Removal
1. Remove top cover as outlined under "COVERS
AND PANELS".
2. Open the door.
3. Pull hinge rod up.
4. Reverse the procedure to install, making sure
the door bushings are in place.
Gasket
1. Open the door.
2. Remove screws from the gasket plate.
3. Pull the gasket plate out from the door housing
and remove the gasket.
4. Position the new gasket on the gasket plate and
reverse the procedure to install. Adjust the door
as outlined under "DOOR SEALING
ADJUSTMENT".
NOTE: Do not over tighten gasket plate screws as
this will compress the gasket excessively and
interfere with proper door sealing.
Page 18 of 40