Network Deployment; Setting Up The Network Camera Over The Internet; Internet Connection Via A Router - Vivotek IP7160 User Manual

Network Deployment

Setting up the Network Camera over the Internet

This section explains how to configure the Network Camera over an Internet
1. If you have external devices such as sensors and alarms, make the connection from the
general I/O terminal block.
2� Connect the camera to a switch via Ethernet cable�
3� Connect the supplied power cable from the Network Camera to a power outlet�
There are several ways to set up the Network Camera over the
up the Network Camera behind a
to use PPPoE�

Internet connection via a router

Before setting up the Network Camera over the Internet, make sure you have a router and follow
the steps below�
1. Connect your Network Camera behind a router, the Internet environment is illustrated below.
Regarding how to obtain your IP address, please refer to Software Installation on page 10 for
details�
Internet
2
router� The second way is to utilize a static
WAN (Wide Area Network )
Router IP address : from ISP
LAN (Local Area Network)
Router IP address : 192.168.0.1
Cable or DSL Modem
3
1
1:Power +12V
2:Digital output
3:Digital input
4:Ground
Ethernet Switch
Internet�
IP address : 192.168.0.3
Subnet mask : 255.255.255.0
Default router : 192.168.0.1
IP address : 192.168.0.2
Subnet mask : 255.255.255.0
Default router : 192.168.0.1
VIVOTEK
connection�
The first way is to set
IP� The third way is
User's Manual - 7