Checking Door Alignment; Adjusting Door Alignment - U-Line CLR2060 Installation Manual

™
Pivot Post
Wood Panel Top Hinge Plate
(5/8" Longer than Existing Top Hinge Plate)
Figure 24
3. Install the pivot post into the new Replacement Bottom
Hinge (using the 7/64" hex key or Phillips screwdriver)
and install the hinge onto the unit.
4. Replace the door closure assembly onto the bottom
pivot post (see Figure 25). Be sure that bosses on
closers align with holes in hinge and hinge plate.
Door Closure Top
Boss
Door Closure Bottom
Boss
Pivot Post
Figure 25
IMPORTANT
Pivot posts must be cleaned. Closers must also be clean
and greased to ensure proper operation.
5. Place the modified door onto the pivot post.
6. Position door and install the pivot post into the top
hinge (using the 7/64" hex key or Phillips screwdriver).
7. Adjust door as needed for proper closure. Go on to 5
Adjust Door.
02/2005
CLR2060 — Clear Ice Maker
#8-32 x 1/2"
Flat Head Screw
Three Places
Top Pivot Plate
Door Panel
Existing
Door
#8-32 x 1/2" Flat Head Screw
Three Places
Wood Panel Bottom Hinge Plate
(5/8" Longer than Existing Bottom Hinge Plate)
5 Adjust Door

Checking Door Alignment

The unit's door is aligned at the factory before shipment.
However, its alignment could have been disturbed during
shipment or during door panel installation.
IMPORTANT
Properly aligned, the door should be 1/8" below the top of
the unit's cabinet, NOT flush with the top (see Figure 26).
1/8"
Figure 26
1. Compare the top edge of the door to the top edge of
the cabinet.
2. If the door edge is 1/8" below and parallel to the top of
the cabinet, go on to 6 Prepare Plumbing. If it is not,
note whether the side opposite the hinge needs to be
moved UP or DOWN, and use the following procedure.

Adjusting Door Alignment

1. Remove top hinge screw
pin (7/64" Allen wrench or
Phillips screwdriver,
depending on your unit's
construction, see Figure
27). Remove door by
tilting forward and lifting
off bottom hinge pin.
2. With door upside-down,
loosen but do not remove
the two screws on the
door's bottom hinge plate.
11
Figure 27
www.U-LineService.com