Wall Mounting; Pole Mounting - Honeywell 5800PIR-RES Installation Instructions Manual

3
Install / Replace the Battery
IMPORTANT:
Use only lithium batteries.
Use four (4) lithium 1.5VDC AA cells. (Energizer L91 or
equivalent.)
Change all four batteries at the same time. Do not mix
weak batteries with new batteries.
Observe polarity.
4
Mount the Sensor

WALL MOUNTING

1.
Install the Back Box on the wall
using two M4 x 20 mounting
screws.

POLE MOUNTING

1.
Use a pole with an outside
diameter of 43-48mm
(1.69-1.89").
2.7- 4ft.
0.8 - 1.2m
1.
If necessary, loosen the Captive
Lock Screw and lift Cover off.
Then, remove 4 screws that secure
the Detector to the Back Box.
2.
Observe the proper polarity and
replace the batteries. Ensure
positive side of battery is pointing
away from the springs.
2.
Secure the Detector to the Back
Box.
3.
Fasten with four self tapping
M3 x 14 screws.
2.
Attach the Brackets to the Back
Box with two M3 x 8 screws.
4.
Perform Settings & Adjustments.
5.
Perform a Walk Test.
6.
Secure the Cover with the M3 x 10 Captive Lock Screw.
7.
Program the control panel.
You may have to move
aside the sponge packing
to reveal the screw holes.
3.
Using the Pole Brackets
and four M4 x 30 screws,
fasten the Back Box to the
pole.
– 2 –
4.
Secure the Detector to
the Back Box and
fasten with four self-
tapping M3 x 14 screws.
5.
Perform Settings &
Adjustments.
6.
Perform a Walk Test.
7.
Secure the Cover with
the M3 x 10 Captive
Lock Screw.
8.
Program the control
panel.