Advertisement
Quick Links
How to Remove and Reposition a Honeywell Carbon Monoxide Sensor Model 5800CO
Description
This page shows how to remove and reposition a Honeywell Carbon Monoxide Sensor Model
5800CO
Please read through the directions in its entirety before commencing.
Preparation
***IMPORTANT customers who use myadt.ca*** Before removing the sensor, place the
panel on test mode through
1. Tap [Home]
2. Tap [Place on Test]
3. Enter your expiration date and time
4. Enter your password
5. Tap [Yes-Proceed]
Parts Required
1. A Phillips screwdriver
2. A thin sharp knife
myadt.ca. After logging in:
Advertisement
Related Manuals for Honeywell 5800CO
Summary of Contents for Honeywell 5800CO
- Page 1 How to Remove and Reposition a Honeywell Carbon Monoxide Sensor Model 5800CO Description This page shows how to remove and reposition a Honeywell Carbon Monoxide Sensor Model 5800CO Please read through the directions in its entirety before commencing. Preparation ***IMPORTANT customers who use myadt.ca*** Before removing the sensor, place the panel on test mode through myadt.ca.
- Page 2 Removal of Carbon Monoxide Sensor 1. Grab the face of the carbon monoxide sensor and twist to the left to release from the back plate 2. Arm and disarm the alarm to clear panel alert 3. Determine if the back plate is attached with adhesive tape or screwed in a.
- Page 3 5. Arm and disarm the alarm to clear panel alert ***If the alert does not clear or if the panel sensor shows tamper, walk through the steps above once more. It could be either the sensor cover is not on properly***...