Floppy Drive Connector - EVGA 133K8NF41AX User Manual

Serial Port COM1/COM2 : COM1/COM2
COM1 is the 9-pin D-Subminiature male connector. The On-board serial port
can be disabled through BIOS SETUP.
Floppy drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting
the single plug end to motherboard, connect the two plugs at other end to the
floppy drives.
Pin 1
Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After connect-
ing the single plug end to motherboard, connect the two plugs at the other end
to your hard disk(s). If you install two hard disks, you must configure the second
drive to Slave mode by setting its jumpers accordingly. Please refer to the
documentation of your hard disk for the jumper settings.
Primary IDE Connector
EVGA.com Corporation 2900 Saturn St. Suite B, Brea, CA 92821
Phone: 888 / 881-EVGA - 714 / 528-4500 - Fax: 714 / 528-4501
FDD

Floppy Drive Connector

IDE 1
Pin 1
Page 23