Table of Contents
Advertisement
COM2/PARALLEL/SPDIF IN/SPDIF OUT
This block area includes the 9 pin connector for COM2, a standard Parallel port
and SPDIF In and Out connectors (using RCA connector type).
Floppy drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting
the single plug end to motherboard, connect the two plugs at other end to the
floppy drives.
FDD
Pin 1
Floppy Drive Connector
Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After connect-
ing the single plug end to motherboard, connect the two plugs at the other end
to your hard disk(s). If you install two hard disks, you must configure the second
drive to Slave mode by setting its jumpers accordingly. Please refer to the
documentation of your hard disk for the jumper settings.
IDE1
Pin 1
Primary IDE Connector
EVGA Corporation 2900 Saturn St. Suite B, Brea, CA 92821
Phone: 888 / 881-EVGA - 714 / 528-4500 - Fax: 714 / 528-4501
Page 23
Advertisement
Table of Contents
