It can adjust temperature, humidity, ventilation and light in your sauna. Sensors......................6 The Saunova 2.0 Control Units are available on a separate or built-in mounting on the Power Sensor location with heaters mounted on the wall ........7 Sensor location with heaters mounted on the floor .......7 Controller.
NOTE! Fig. 3 room or in places where temperature Saunova 2.0 user interface can be installed either rubber cable or its equivalent. The use of inside or outside the sauna room. Only one user can exceed 40°C. It is protected against PVC-insulated cable as a connecting cable interface can be used to control the heater.
Contactor Unit Sensor location with heaters mounted on the wall Follow the instructions that are supplied If the heater used is more than 9 kW, Fig. 5 TEMPERATURE SENSOR WITH FUSE ON THE WALL together with the contactor unit. an additional contactor is needed. The Air Vent Sensor 2 (Optional) contactor unit is linked to the main Power...
Technical Diagram Fig. 9 Saunova 2.0 Control Unit Main Switch RJ Data Cable For Heaters more than 9 kW Interface 1 1 0 1 CONTACTOR UNIT Heater >9 kW SESSION 1 2 3 SAU-UI-V2 CONTROL SAFETY SAFETY SWITCH Max. 9.0 kW...
Maximum Session Time The Power Controller Main Switch 24 hours, it will be ON constantly. It needs to The maximum sauna session time depends The power controller switch can be found on the top on the purpose of the sauna. For domestic be continuously monitored.
DIP Switch Description Power Rating Remarks Description Power Rating Remarks Control Steamer R ated P ower 3 Phases 3kW AC1 SESSION R ated P ower 3 Phases 9kW AC1 R ated P ower S ingle Phase 3kW AC1 (3 x 3kW) R ated Voltage 230V 1N~ R ated Voltage 3 Phases...
Need help?
Do you have a question about the SAUNOVA 2.0 and is the answer not in the manual?
Questions and answers