Sawo SAU-PC-V2 Manual

Sawo SAU-PC-V2 Manual

Power controller

Advertisement

Quick Links

MANUAL
POWER CONTROLLER
Not for use in the USA, Canada and Mexico.
ENGLISH

Advertisement

Table of Contents
loading

Summary of Contents for Sawo SAU-PC-V2

  • Page 1 MANUAL POWER CONTROLLER Not for use in the USA, Canada and Mexico. ENGLISH...
  • Page 2: Table Of Contents

    TABLE OF CONTENTS Introduction of the Saunova 2.0 Control............3 Precautions .......................3 Power Controller ....................4 Control Unit to Heater ..................5 Contactor Unit ....................6 Sensors ......................6 Sensor location with heaters mounted on the wall ....... 7 Sensor location with heaters mounted on the floor ......7 Technical Diagram .....................8 Maximum Session Time ...................10 Door Sensor/Switch ..................10...
  • Page 3: Introduction Of The Saunova 2.0 Control

    INTRODUCTION OF THE SAUNOVA 2.0 CONTROL Congratulations on your purchase of Saunova 2.0 Control Unit! Saunova 2.0 Control Unit is developed to enhance your sauna bathing with a variety of different features. It can adjust temperature, humidity, ventilation and light in your sauna. The Saunova 2.0 Control Units are available on a separate or built-in mounting on the Power Controller.
  • Page 4: Power Controller

    Power Controller The Power controller or the separate control The heater is connected to the electrical panel must not be located inside the sauna network semi-stationarily with a H07RN-F room or in places where temperature rubber cable or its equivalent. The use of can exceed 40°C.
  • Page 5: Control Unit To Heater

    Control Unit to Heater Connection Diagram NOTE! Fig. 3 Saunova 2.0 user interface can be installed either inside or outside the sauna room. Only one user interface can be used to control the heater. INSIDE SAUNA ROOM OUTSIDE SAUNA ROOM NOTE! SENSOR(S) If the Saunova 2.0 user interface...
  • Page 6: Contactor Unit

    Contactor Unit Follow the instructions that are supplied If the heater used is more than 9 kW, together with the contactor unit. an additional contactor is needed. The contactor unit is linked to the main Power Controller with a RJ12 cable (Fig.4). Installation of separate control panel with Fig.
  • Page 7: Sensor Location With Heaters Mounted On The Wall

    Sensor location with heaters mounted on the wall Fig. 5 TEMPERATURE SENSOR WITH FUSE ON THE WALL Air Vent Sensor 2 (Optional) Temperature Sensor See Airvent installation NOTE Do not place the sensors too near to air ventilation (not under 1000mm) or not under 500mm from air ventilation, which is directed away from sensors.
  • Page 8: Technical Diagram

    Technical Diagram Fig. 9 RJ12 Data Cable Saunova 2.0 Control Unit Main Switch For Heaters more than 9 kW Interface -Power Controller 1 1 0 1 CONTACTOR UNIT Heater >9 kW 0.35m -Power Controller with Built-in Control Panel SESSION 1 2 3 SAU-UI-V2 CONTROL SAFETY...
  • Page 9: Maximum Session Time

    Maximum Session Time 24 hours, it will be ON constantly. It needs to The maximum sauna session time depends be continuously monitored. on the purpose of the sauna. For domestic use, the total on-time of the sauna is limited The maximum heater on-time is set by to 6 hours.
  • Page 10: The Power Controller Main Switch

    The Power Controller Main Switch The power controller switch can be found on the top end of the unit. Using this switch, you can isolate the electronics from the mains power supply. UNIT ON LIGHT ON ENGLISH...
  • Page 11: Dip Switch

    DIP Switch SESSION DIP Switch Functions DIP Switch # Function Session time Session time Session time Combi mode Combi mode ON Combi mode OFF Slave Contactor Controller Combi heater with Combi heater with Empty 1 signal (Wm) for 2 signal (Empty & Level) for water level detection water level detection Safety/door switch...
  • Page 12 Description Power Rating Remarks Description Power Rating Remarks Control Steamer Rated Power 3 Phases 3kW AC1 Rated Power 3 Phases 9kW AC1 Rated Power Single Phase 3kW AC1 (3 x 3kW) Rated Voltage 230V 1N~ Rated Voltage 3 Phases 400V 3N~ Switching capacity 16A (3 Phases), Rated Power Single Phase...
  • Page 13 PX 4 Subject to change without notice. www.sawo.com | info@sawo.com...

This manual is also suitable for:

Saunova 2.0

Table of Contents