Aquaglide CYCLONE WHEEL Owner's Manual page 7

Chart 1 – Working Pressure by Chamber - Cyclone Wheel
Valve [Inflate Order]
MAIN [1]
1. Locate a flat, dry area with access to outlet for electrical pump. The best setup position will also make
launching easy. Never drag product as damage may occur.
2. Unfold product completely and locate Main Valve [1]. To help future storage, closely note original folding &
packaging method. Remove valve cap and confirm valve is in inflate (1-way airflow) position.
3. Insert air pump hose with proper valve fitting into Main Valve [1], lock into place. Use pump to inflate Main
Valve [1] to Working Pressure as shown in Chart 1.
4. Confirm that suitable anchor(s) and mooring lines are in place before launching this item (see Anchoring).
5. To launch product, lift completely and place in water. Large items may require many extra people to
accomplish this. Never drag product as damage may occur.
6. Cyclone Wheel is not designed to be connected with other items in Aquaglide's modular system. This item
is intended to be used with Cyclone Enclosure to contain it, or to be continually supervised by boat when in
use.
Proper anchoring is essential to the safety and performance of this product. We recommend using Aquaglide
mooring lines and weight recommendations as a starting point. Weight recommendations are intended to
keep products in place during a normal range of weather conditions faced by most aquaparks. Even in so-
called light-wind areas, storms, squalls and other extreme weather events can happen quickly. If improperly
anchored, product can move and/or float away. Aquaglide is not responsible for damage, injury or loss due to
improper anchoring.
Open Water: (General guidelines - not intended to replace need for professional installation)
1. Place product in an area protected from wind and boat traffic. Confirm allowances for stated minimum
water depth, safe distance away from hard objects and vertical clearance requirements.
2. Consider prevailing conditions such as wind, waves and other environmental factors in positioning this
item. Inflatable items can be unstable in strong winds. Slide faces are best positioned toward a breeze, not
across it. Check water and seabed for sharp or dangerous objects.
3. Keep product a safe distance from docks, boats, boat lifts, and any other structures. To prevent potential
damage to product, injury or death, NEVER tie the product to a dock.
4. Cyclone Wheel may be anchored in two ways:
a. If enclosed by a properly anchored Cyclone Enclosure, Cyclone Wheel may be anchored by attachment
to Cyclone Enclosure using a single anchor line. In this case, no additional anchor weight is necessary.
b. If Cyclone Enclosure is NOT in use, Cyclone Wheel should be anchored using one vertical mooring line
with an appropriate weight anchor, ground screw, or earth anchor at base. In this case, see requirements
below.
7
Working Pressure in psi (Bar)
1.5psi (0,103 bar)
ANCHORING
www.aquaglide.com