Table of Contents
Advertisement
Chapter 1 - Introduction
System Requirements
Before connecting the cable modem to your PC, make sure your system is
equipped with a LAN controller and supports the TCP/IP protocol.
Installing a Network Card
Preparations
If your system does not have an embedded LAN controller, you must install
a network interface card as instructed below (assuming that you are using
an Ethernet card under the operating system of Windows 98):
1. Install the network card on your
motherboard.
2. Power up your PC and follow the
Add New Hardware Wizard's
instructions to install the driver.
When asked to restart your
computer at the end of the
installation, click Yes.
6
3. After restarting the system, right-
click My Computer on the
desktop, select Properties, click
the Device Manager tab, and then
double-click Network adapters
to confirm that the Ethernet driver
is properly installed.
Cable Modem User's Manual
Advertisement
Table of Contents
