Page 2
Products and corporate names appearing in this manual may or may not be registered trademarks or copyrights of their respective companies, and are used only for identification or explanation and to the owners’ benefit, without intent to infringe. Product Name: ACM6000EB Cable Modem Manual Revision: 1.00 E580 Release Date:...
Introduction Thank you for purchasing the ASUS ACM6000EB DOCSIS-compliant cable modem. This Overview cable modem delivers the highest performance in data over cable technology. Ideal for home and small business users, this easy-to-use communication device offers reliable connectivity as well as remarkable data transfer rates--up to 43Mbps downstream and 10Mbps upstream, 100 times faster than a 56K dial-up modem.
If your system does not have an embedded LAN controller, you must install a network Installing a interface card as instructed below (assuming that you are using the ASUS PCI-L101 Fast Network Card Ethernet card under the operating system of Windows 98): 1.
Preparations • Checking if TCP/IP is already installed Installing the 2. In the list of installed network compo- TCP/IP 1. Click the Start button on the nents try to find the TCP/IP protocol. It desktop. In the Settings menu, select Protocol may be followed by the name of the Ethernet controller.
Using the Cable Modem Front Panel POWER STATUS CABLE TEST LED Indicator State Description 1. Power LED Modem is powered ON Modem is powered OFF 2. Status LED Modem successfully registered on cable operator’s network Flashing Modem is registering on cable operator’s network (While Cable Link LED is flashing) searching for downstream channel 3.
Using the Cable Modem Rear Panel DC+5V/2A Cable Console Reset 10/100-BaseT 1. DC +5V/2A Power Input Jack The provided power adapter converts AC power to DC power for use with this jack. Power supplied through this jack will supply power to the cable modem. 2.
Using the Cable Modem Take the following steps to accomplish the installation procedure: Installing the 1. Connect the cable TV coaxial cable to the input connector of a signal splitter. Cable Modem 2. Connect a coaxial cable from one of the output connectors on the splitter to the input connector of your TV set.
Using the Cable Modem Powering Up When all connections have been properly made and the power is ON, the cable modem will automatically start the self-test and search for the active cable channel provided by your cable operator. Now you are all set and ready to surf the internet at a marvelous speed! The cable modem supports up to 15 pieces of consumer premises equipment.
This product meets all safety requirements per UL-1950 standard. This certificate of conformity is based on an evaluation of the ACM6000EB product that is in compliance with the Low Voltage Directive 73/23/EEC and the Amendment Directive 93/68/...
Product Specifications Hardware Specification RF Infterface • F-Type female 75ohm connector Console • UART serial interface CPE Interface • 10Base-T/100Base-TX Ethernet (RJ-45) • USB (optional) Dimensions (H x W x D ) • 34.60 x 202.95 x 182.50mm Weight • 470g Power Consumption •...
Page 15
Product Specifications (This page was intentionally left blank.)
Page 16
Product Specifications (This page was intentionally left blank.)