Related Manuals for Siemens VersiCharge Blue 80A
Summary of Contents for Siemens VersiCharge Blue 80A
- Page 1 INSTALLATION MANUAL VersiCharge 95" Post and Integrated Retraction Systems US.: SI-VB80A-95R-.B-01 usa.siemens.com/versicharge...
- Page 2 Introduction Safety Instructions Tools and Materials VersiCharge Blue 80A 95” Post Mounting Instructions and Integrated Retraction Systems Maintenance Installation Manual Warranty Help! Appendix 03/2025 Rev 02...
- Page 3 Note the following: WARNING Siemens products may only be used for the applications described in the catalog and in the relevant technical documentation. If products and components from other manufacturers are used, these must be recommended or approved by Siemens. Proper transport, storage, installation, assembly, commissioning, operation and maintenance are required to ensure that the products operate safely and without any problems.
-
Page 4: Table Of Contents
General Exterior Maintenance................... 27 General External Checks....................27 Spare Parts........................Warranty............................. 29 Help!..............................30 Appendix............................Dimensions single post (in inches)..................31 Dimensions dual post (in inches)..................33 VersiCharge Blue 80A 95” Post and Integrated Retraction Systems Installation Manual, 03/2025, Rev 02... -
Page 5: Introduction
• Personal injury • Material damage • Dangerous situations • Loss of warranty Current offerings: Siemens offers the following VersiCharge™ 95" Post and Integrated Retraction Systems variants: Description Catalog number VersiCharge 80A 95" single post with retractable cable management 8EM13931PA12 VersiCharge 80A 95"... - Page 6 Introduction contract contains the entire obligation of Siemens. The warranty contained in the contract between the parties is the sole warranty of Siemens. Any statements contained herein do not create new warranties or modify the existing warranty. Permits Be aware that many areas require special permits and/or utility approvals to install EV charging equipment.
-
Page 7: Safety Instructions
WARNING This indicates a situation where failure to follow instructions may be a safety hazard or cause equipment malfunction. Use extreme caution and follow instructions carefully. VersiCharge Blue 80A 95” Post and Integrated Retraction Systems Installation Manual, 03/2025, Rev 02... -
Page 8: Tools And Materials
Tools and Materials Required tools for installation T25 & T30 Security Torx bit drivers VersiCharge Blue 80A 95” Post and Integrated Retraction Systems Installation Manual, 03/2025, Rev 02... -
Page 9: Supplied Parts For Installation
Tools and Materials 3.2 Supplied Parts for Installation Supplied Parts for Installation 3.2.1 Supplied Parts for Dual Model VersiCharge Blue 80A 95” Post and Integrated Retraction Systems Installation Manual, 03/2025, Rev 02... -
Page 10: Supplied Parts For Single Model
Tools and Materials 3.2 Supplied Parts for Installation 3.2.2 Supplied Parts for Single Model VersiCharge Blue 80A 95” Post and Integrated Retraction Systems Installation Manual, 03/2025, Rev 02... -
Page 11: Mounting Instructions
Mounting Instructions VersiCharge Blue 80A 95” Post and Integrated Retraction Systems Installation Manual, 03/2025, Rev 02... -
Page 12: Pedestal And Pedestal Base Dimensions (In Inches)
Pedestal Front View ② Pedestal Iso View For more information on the post dimensions, see the appendices Dimensions single post (Page 31) and Dimensions dual post (Page 33). VersiCharge Blue 80A 95” Post and Integrated Retraction Systems Installation Manual, 03/2025, Rev 02... - Page 13 Mounting Instructions 4.1 Pedestal and pedestal base dimensions (in inches) Base Plate Dimensions (in inches) VersiCharge Blue 80A 95” Post and Integrated Retraction Systems Installation Manual, 03/2025, Rev 02...
-
Page 14: Site Preparation And Base Requirements
The conduit length should be cut to ensure the conduit opening rests vertically inside the raceway to prevent entry to water and other contaminants. Siemens recommended a minimum length of 20” for the conduits. However, if installer wants to run conduit all the VersiCharge Blue 80A 95”... -
Page 15: Single/Dual Post And Cable System Installation
4.3 Single/Dual Post and Cable System Installation way to the bottom of the raceway and allow for some adjustability to cut conduit to length from the top of the 3” x 6” raceway. Siemens recommended conduit lengths would be: • Single Enclosure: 44”... - Page 16 Power and communication cables must be run in separate conduits according to NEC standards. If they are too close together, there will be interference that negatively affects communication. VersiCharge Blue 80A 95” Post and Integrated Retraction Systems Installation Manual, 03/2025, Rev 02...
- Page 17 ¾” SS pan head T30 torx drive screws with (2) ¼” SS flat washers into the threaded base plate. For further details, refer to the image below. Figure 4-2 Secure retractor baseplate to pedestal baseplate VersiCharge Blue 80A 95” Post and Integrated Retraction Systems Installation Manual, 03/2025, Rev 02...
- Page 18 T30 torx drive screws through retractor mounting holes, through the pedestal threaded mounting holes. For further details, refer to the image below. Figure 4-3 Attaching upper portion of retractor to 3”x6”x32” pedestal VersiCharge Blue 80A 95” Post and Integrated Retraction Systems Installation Manual, 03/2025, Rev 02...
- Page 19 – Dual Model Left (facing front of post): 27” – Single Model: 23” For further details, refer to the image below. Figure 4-4 Cut wires length of power cables VersiCharge Blue 80A 95” Post and Integrated Retraction Systems Installation Manual, 03/2025, Rev 02...
- Page 20 (4) 10-32 X ½”SS pan head T25 torx drive screws. For further details, refer to the image below. Figure 4-6 Attaching dual or single mounting bracket to retractor VersiCharge Blue 80A 95” Post and Integrated Retraction Systems Installation Manual, 03/2025, Rev 02...
- Page 21 T25 torx drive screws onto the single or dual enclosure. For further details, refer to the image below. Figure 4-8 Install holster(s) onto dual or single enclosure VersiCharge Blue 80A 95” Post and Integrated Retraction Systems Installation Manual, 03/2025, Rev 02...
- Page 22 EVSE’s instructions. For further details, refer to the image below. Figure 4-10 Relocate sealing plug from rear entry to open bottom hole VersiCharge Blue 80A 95” Post and Integrated Retraction Systems Installation Manual, 03/2025, Rev 02...
- Page 23 1. Attach the power wires (L1, L2 and GND), followed by the communication wires per the VersiCharge Blue™ 80 | Installation Manual. NOTE Prior to wiring, the optimal power wire length inside the EVSE shall be cut to Siemens recommended length: – L1 Wire (Black): 9.5”...
- Page 24 Security-Torx included with the VersiCharge hardware. 3. For dual model, repeat steps in section Installing the EVSE and Wiring the EVSE on opposite side of the enclosure. VersiCharge Blue 80A 95” Post and Integrated Retraction Systems Installation Manual, 03/2025, Rev 02...
- Page 25 Failure to properly secure the clamp to the charging cable may result in injury or damage to a person(s), charging cable, charging station unit and/or pedestal/retractor unit. VersiCharge Blue 80A 95” Post and Integrated Retraction Systems Installation Manual, 03/2025, Rev 02...
- Page 26 7. For dual cable retractor systems, repeat steps 1 through 7 on opposite side of the post. 8. Turn on the power feed to the charging station(s) and test per the VersiCharge Blue™ 80 | Installation Manual. VersiCharge Blue 80A 95” Post and Integrated Retraction Systems Installation Manual, 03/2025, Rev 02...
-
Page 27: Maintenance
• Retractor System – Inspect the retractor system for operation and damage, making sure to check that the rope is not frayed or damaged. VersiCharge Blue 80A 95” Post and Integrated Retraction Systems Installation Manual, 03/2025, Rev 02... -
Page 28: Spare Parts
– Remove any debris or snow buildup around the unit, especially in areas with heavy snowfall. – This should be checked daily in winter conditions. If damage is observed, contact your supplier or Siemens directly by creating a support ticket as described in the Help! section (Page 30). Spare Parts Available spare parts for the 95”... -
Page 29: Warranty
Product Warranties • VersiCharge™ - Applies to all VersiCharge™ (https://assets.new.siemens.com/siemens/assets/api/uuid: aa957eb2-0e18-4983-a559-6c9a30851e1d/SIE-B40053-00-4AUS-VersiCharge-AC-Limited- Warranty.pdf) Accessories Warranties • VersiCharge™ Accessories - Applies to all VersiCharge™ accessories (https://assets.new.siemens. com/siemens/assets/api/uuid:90a9692a-5992-4b03-bea5-fa30f63f324c/SIE- B40059-00-4AUS-VersiCharge-AC-Accessories-Limited-Warranty_original.pdf) VersiCharge Blue 80A 95” Post and Integrated Retraction Systems Installation Manual, 03/2025, Rev 02... -
Page 30: Help
Help! Call us any time, any day, at +1 (855) 950-6339, option 9, or contact us via support ticket at (https://emobility.usa.siemens.com/s/eMobilityCloud). VersiCharge Blue 80A 95” Post and Integrated Retraction Systems Installation Manual, 03/2025, Rev 02... -
Page 31: A Appendix
Appendix Dimensions single post (in inches) VersiCharge Blue 80A 95” Post and Integrated Retraction Systems Installation Manual, 03/2025, Rev 02... - Page 32 Appendix A.1 Dimensions single post (in inches) ① 95” single post - ISO view ② 95” single post - front view VersiCharge Blue 80A 95” Post and Integrated Retraction Systems Installation Manual, 03/2025, Rev 02...
-
Page 33: Dimensions Dual Post (In Inches)
① 95” single post - left view ② 95” single post - rear view ③ 95” single post - rear view Dimensions dual post (in inches) VersiCharge Blue 80A 95” Post and Integrated Retraction Systems Installation Manual, 03/2025, Rev 02... - Page 34 Appendix A.2 Dimensions dual post (in inches) ① 95” dual post - ISO view ② 95” dual post - front view VersiCharge Blue 80A 95” Post and Integrated Retraction Systems Installation Manual, 03/2025, Rev 02...
- Page 35 A.2 Dimensions dual post (in inches) ① 95” dual post - left view ② 95” dual post - rear view ③ 95” dual post - right view VersiCharge Blue 80A 95” Post and Integrated Retraction Systems Installation Manual, 03/2025, Rev 02...
- Page 36 Siemens Industry, Inc. including field conditions and project parameters. Siemens does not make representations, warranties, or assurances as to the accuracy or completeness of the content contained herein. Siemens reserves the United States of America right to modify the technology and product specifications in its sole...
Need help?
Do you have a question about the VersiCharge Blue 80A and is the answer not in the manual?
Questions and answers