Anova Madison RCPMT4 Assembly Instructions

Recycle plastic conversation table/thermory conversation table

Download this manual

Assembly Instructions

Madison Recycle Plastic Conversation Table — RCPMT4

Madison Thermory Conversation Table — THMT4

Tools Needed

1/2" Open-end or Box-end Wrench

Ratchet with 1/2" Socket

18 Volt (or higher) Drill w/Phillips Bit & Extension

Component Parts

Hardware Included

12 x 1.5" Phillips Heaf Screw

Note: Additional hardware are not needed for this asssembly may be included as extras.

Assembly Instructions

This assembly is a two-person operation.

1. Inspect the shipping container contents for damaged or missing components.

2. Lay all parts on a soft work surface or on the shipping packaging to prevent damage to finish.

NOTE: Before assembly, it is recommended that a light oil or petroleum jelly be applied to any threads.

Recycle Plastic

5/16" Nyloc Nut (8)

(800) 231-1327

specify@anovafurnishings.com

anovafurnishings.com

Thermory

5/16" Flat Washer (8)

Nov-2024

Need help?

Do you have a question about the Madison RCPMT4 and is the answer not in the manual?

Page 1 2. Lay all parts on a soft work surface or on the shipping packaging to prevent damage to finish. NOTE: Before assembly, it is recommended that a light oil or petroleum jelly be applied to any threads. © 2024 ANOVA® Nov-2024...
Page 2 Install No. 12 screws through the Channel and Leg Frame and into the matching pre-drilled holes in the plank ends. Don’t drive the screw all the way in, leave it loose so there can be some adjustments made as other planks are installed. © 2024 ANOVA® Nov-2024...
Page 3 This product requires only periodic cleaning with a sponge and a solution of mild detergent and water to remove surface dirt. • Do not clean with a solvent or petroleum based products. Manufactured in the U.S. © 2024 ANOVA® © 2024 ANOVA® Nov-2024 Nov-2024...

Madison thmt4