Anova D1404 Assembly Instructions

anovafurnishings.com
888.535.5005 tel
TOOLS needed:
• Ratchet with 1/2" Socket
• Ratchet with 3/4" Socket
• 1/2" Open-end or Box-end Wrench
• 3/4" Open-end or Box-end Wrench
• Level
aSSeMBLY Hardware:
8 — 1/2 x 5.5"
Hex Head Bolt
6 — 1/2-13 x 1.5"
Hex Head Bolt
20 — 5/16" X 1.25"
Hex Head Bolt
aSSeMBLY:
The assembly is a two-person operation.
1. Inspect the shipping container contents for damage and to determine that all components and hardware are present.
2. Locate the Surface Mount Support and the Tabletop
Adapter and lay them out on the packing cardboard
or other soft surfaced workspace.
3. Align the mounting holes in the Tabletop
Adapter with the holes in the appropriate end
of the Surface Mount Support. Install one of the
1.375" O.D. Washers onto one of the 1/2" x 1.5" Long
Bolts and insert the Bolt through both parts, with
the Bolt head on the outside surface of the Surface
Mount Support. Install a 1.375" O.D. Washer and
1/2" Nylon Insert Nut on the inside end of the Bolt.
Use the Ratchet with 3/4" Socket and 3/4" Wrench to
tighten the Nuts.
Repeat this for the other two mounting holes on the
top side of the Adapter/Support assembly.
Turn the assembly over and repeat for the three
mounting holes on the other side of the assembly.
aSSeMBLY InSTrucTIOnS
d1404 46" Square Table
F1403 46" Round Table
F1404 46" Square Table
28 — 1.375" O.D. 14 — 1/2-13"
Washer
Nylon Insert Nut
20 — 5/16"
40 — 5/16"
Flanged Hex Nut
Washer
BencH cOMpOnenTS:
1 — In Ground Support
4 — Seat Supports
1 — Tabletop Adapter
Tabletop Adapter
Surface Mount Support
Model F1403 shown.
Tabletop shape and pattern may vary.
Seat shape and pattern may vary.
4 — Seats
(Straight or Curved)
1 — Tabletop
(Square or Round)
Packaging cardboard or
other soft work surface
Surface Mount Support
Tabletop Adapter
1.5" Long Bolt
1.375" O.D. Washer
1.375" O.D. Washer
Nylon Insert Nut