Anova D1005 Assembly Instructions

anovafurnishings.com
888.535.5005 tel

tools neeDeD:

• Ratchet with 1/2" Socket
• Ratchet with 3/4" Socket
• 1/2" Open-end or Box-end Wrench
• 3/4" Open-end or Box-end Wrench
• Level

Assembly HArDwAre:

8 — 1/2 x 5.5"
Hex Head Bolt
6 — 1/2-13 x 1.5"
Hex Head Bolt
20 — 5/16" X 1.25"
Hex Head Bolt

Assembly:

The assembly is a two-person operation.
1. Inspect the shipping container contents for damage and to determine that all components and hardware are present.
2. Locate the Inground Support and the Table
top Adapter and lay them out on the packing
cardboard or other soft surfaced workspace.
3. Align the mounting holes in the Table top
Adapter with the holes in the appropriate end
of the Inground Support. Install one of the
1.375" O.D. Washers onto one of the 1/2" x
1.5" Long Bolts and insert the Bolt through both
parts, with the Bolt head on the outside surface of
the Inground Support. Install a 1.375" O.D. Washer
and 1/2" Nylon Insert Nut on the inside end of the
Bolt.
Use the Ratchet with 3/4" Socket and 3/4" Wrench
to tighten the Nuts.
Repeat this for the other two mounting holes on
the top side of the Adapter/Support assembly.
Turn the assembly over and repeat for the three
mounting holes on the other side of the assembly.
4. Determine the location for Table.
IMPORTANT: Locate underground utilities and avoid
them while digging the hole for the concrete base.
ASI 145_O HRD88 S117
Assembly InstructIons
D1005 46" Round Table
D1080 46" Square Table
D1081 46" Square Table
D1135 46" Square Table
D1192 46" Round Table
D1193 46" Round Table
F1005 46" Round Table
F1019 46" Round Table
F1072 46" Octagon Table
F1074 46" Octagon Table
F1078 46" Square Table
F1080 46" Square Table
F1081 46" Square Table
F1135 46" Square Table
F1191 46" Octagon Table
bencH components:
28 — 1.375" O.D. 14 — 1/2-13"
Washer
Nylon Insert Nut
20 — 5/16"
40 — 5/16"
Flanged Hex Nut
Washer
F1192 46" Round Table
F1193 46" Round Table
F2121 46" Octagon Table
r1111I 46" Square Table
r1113I 46" Round Table
Model D1005 shown.
Tabletop shape and pattern may vary.
Seat shape and pattern may vary.
1 — In Ground Support
2, 3, or 4 — Seat Supports
1 — Tabletop Adapter
Tabletop Adapter
Inground Support
2, 3, or 4 — Seats
(Straight or Curved)
1 — Tabletop
Round, Square, or Octagon
Packaging cardboard or
other soft work surface
Inground Support
Tabletop Adapter
1.5" Long Bolt
.562" ID Washer
.562" ID Washer
Nylon Insert Nut